To replace the distributor cap in a Mitsubishi Diamante, first, disconnect the negative battery cable to ensure safety. Remove the ignition wires from the old distributor cap, taking note of their order for reinstallation. Unscrew and remove the old cap, then attach the new cap securely, re-connecting the ignition wires in the correct sequence. Finally, reconnect the battery cable and start the engine to ensure proper function.
To replace the distributor cap on a Mitsubishi Diamante, first, ensure the engine is off and cool. Disconnect the negative battery terminal for safety. Remove the screws or clips holding the distributor cap in place, then carefully detach the cap from the distributor. Install the new cap by aligning it properly, securing it with screws or clips, and reconnecting the battery terminal.
To change the distributor cap on a 2003 Mitsubishi Diamante, first ensure the engine is off and cool. Disconnect the negative battery cable, then remove the screws or clips securing the distributor cap. Carefully lift off the old cap, noting the position of the ignition wires, and transfer them to the new cap. Finally, secure the new cap in place, reconnect the battery, and start the engine to check for proper operation.
The cam shaft position sensor is located under the distributor cap. You can replace this easily by undoing the screws holding on the distributor cap, remove and replace the sensor, then just replace the distributor cap.
The gas cap release for a Mitsubishi Diamante is located in the trunk, on the left side. There is a cable with a handle on it running down from the top left of the trunk, and you'll need to pull it to manually release the gas cap.
you dont have a distributor cause it is electronically distributed wich means that the computer does it
it is distributorless no cap to replace has coil packs
there is no distributor on a 98 rav. therefore no cap or rotor. replace the plugs and wires and the tuneup is done
how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.
1,3,4,2
Replace the screws.
The distributor cap is to the rear of the engine behind the air intake. To replace it, I recommend moving the air intake out of the way.
Remove the center console/cupholder. Remove the interior doghouse. Remove distributor cap.