If the wires have been pulled off the 2 x red/black go to pin 15 on the switch. Red goes to 30 (pos. from battery). Blue goes to 50 (starter motor). Yellow to X. White/red to S. and blue/yellow to the un-named contact.
wires on the starter are criss crossed
Yes, there is an engine wiring schematic for a 1981 Volvo 242 DL. You can find this schematic online at places like Volvo Tips and E Euro Parts.
Trunk LH side behind the trunk panel liner. You will find the Rear Electrical module there. Part number on the brake light relay should be 9441161. You will need some sort of wiring diagram as there are a couple of relays used there with that same part number.
The Chiltons/Haynes 72300 has the vacuum circuits divided into the emissions, Fuel and brakes sections of their manual covering each vacuum hose.
Check the neutral safety switch Check battery cables for looseness or corrosion change the ignition starter relay found in the engine bay goggle ignition starter relay to view it.
http://www.google.com/ Google it. :)
One can find a wiring diagram for a Volvo 245 at Turbo Bricks. These can also be found at Volvo Club and at Volvo Tips.
infolinks.com free pdf diagrams... took me forever to find these... be blessed
When working on anything electrical, a person should have a diagram. The diagram for the alternator wiring for a 1985 Volvo 240 can be found in its maintenance manual.
how i can know about lamp wiring... type of Volvo 1984 injection modul
To replace the ignition switch on a Volvo 740, first disconnect the battery to ensure safety. Remove the plastic cover around the steering column for access, then detach the ignition switch by unscrewing it and disconnecting the wiring harness. Install the new ignition switch by reversing the removal process, ensuring all connections are secure, and finally, reattach the steering column cover. Reconnect the battery and test the new ignition switch to ensure it functions properly.
Im installing a 1983 2.3 red block into a 1979 242. I need a ignition wiring road map Modified schematic. Bkindschy@yahoo.com
To remove and replace the ignition switch electric part on a 1992 Volvo 940 sedan, first disconnect the battery to ensure safety. Then, remove the plastic cover surrounding the steering column and locate the ignition switch. Disconnect the wiring harness from the ignition switch, unbolt it from its position, and replace it with the new switch. Finally, reassemble the steering column cover and reconnect the battery.
You need to contact Volvo with the last 8 digits of your VIN.
check that switch it's probably defective or for some reason its staying "open" it may simply be faulty wiring.
A person can get a wiring diagram for a Volvo S40, O2 sensor at most auto part stores. A Volvo dealership will also be able to help you with a wiring diagram.
this is prob. not the most helpful answer but i bought a hynes book from the pepboys near me and it had a wiring diagram in the back. cost around $20