answersLogoWhite

0

If the fuses are good, and the light has not been busted up, get a test light and probe the wire and socket to see if you are getting any juice. If not, trace the wire all the way back to the box and check for a break. The easier way to check for a break, get a digital multimeter, set it to ohms, (the Greek Omega Symbol) and hook one side -it doesnt matter which- to the fuse box in the slot where the fuse goes and probe the socket where the bulb goes, if you get any reading, the wire is not broken, if it says OFL, 0 , or anything but fluctuating numbers, you have a break.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

On a 2005 Toyota 4Runner why would the right turn signal and brake light not work but the tail light works?

Have you checked the fuses or bulbs?


Replace rear bulb Toyota 4Runner?

To replace the rear bulb in a Toyota 4Runner remove the plastic covers located in the trunk. Taking off the plastic covers will reveal the taillight housing and bulbs. Replace the bulbs.


When you push in your brakes on my 91 Toyota 4Runner why does the dashlights come on?

Check the brake light bulbs, one of them may not be installed correctly.


Left turn signal works right one does not hazard works on jeep?

Assuming you have checked all of the bulbs, sockets and wiring, the signal flasher could be weak or the signal switch is bad.


Why does the side turn signal indicator lights on my 1998 Toyota corrolla fail to flash after replacing both right and left side bulbs and flasher?

You have to replace front and rear bulbs.


How do you remove the corner tail light cover on a 1992 Toyota Previa in order to change the rear turn signal?

Remove the light assy then turn the bulbs countereclockwise to remove the bulbs.


Both brake lights stopped working on 91 4runner. Have checked wiring bulbs fuses and they're all ok.?

Check the brake light switch it should be connected to the brake pedal somewhere.


How do you replace dash lights on 93 4 Runner?

The dash lights on a 93 Toyota 4Runner are replaced by removing the dash trim and panels. When the dash internals are exposed, the individual bulbs can then be replaced.


Why won't the turn signals work in a 2001 Toyota corolla?

probably because you need to get new light bulbs, go get that checked!! that's dangerous


Changing front signal bulbs on RSX?

Front signal bulbs on a RSX are changed from the engine bay. Find the lightbulbs for the signal bulbs located towards the bumper of the vehicle. Pull them out and replace them.


What is wrong with a 1971 ford econoline 250 if when you put on the turn signal both turn signals stay on solid instead of blinking all the bulbs have been checked and they all work fine?

turn signal flasher


Are the turn signal bulbs and hazard bulbs the same bulbs?

Turn signal bulbs and hazard bulbs are the same bulb. When the turn signal is turned on, the indicator light on the dash flashes in tune with the turn signal. When the hazard lights are turned on, an extra fuse which is live, powers the hazard flashers, even if the car is turned off.