I'm having the same problem with a 1987 Ford E350 with a 460 auto trans. I just replaced the engine with a used one from a 1988 ford F250 with a 460 4wd auto trans. and now the starter won't release from the flywheel and it is making a bad grinding sound. I searched around on the net a little bit and it looks like all the 460 from 84-91 list the same part numbers for the starter, and flywheel. my old starter had some movement in the shaft and sounded like it was grinding a little so, I replaced the it with a new one from Auto Zone. And it still dose the same thing. There is no adjustments to be made with a ford starter like a GM starer. It should just bolt right up and that's it. So now I'm not sure what to do. I don't work on fords that much so if you have any ideas please let me know.
Ford F150 Starter LocationBased on my owning several Ford pickups over the last 20 some years, Ford F150 starters are located on the right [curbside / passenger side] of the engine, down near the bottom of the block [just above the top edge of the oil pan] and on the rear flange of the engine on which the transmission and/or clutch bell housing attaches.
the starter is located right below the factory air filter box
could be a worn pinion gear or bad U joint or both
Three bolts to take the old one out, take the wires of the old starter and put on the new. Replacement is the opposite of removal.
I believe 18 gals. in front tank and 20 gals. in rear
Location of starter on 89 ford f150
The starter solenoid is not disengaging once engine is started. Rebuild starter or replace with a new starter.
On the Starter
Ford F150 Starter LocationBased on my owning several Ford pickups over the last 20 some years, Ford F150 starters are located on the right [curbside / passenger side] of the engine, down near the bottom of the block [just above the top edge of the oil pan] and on the rear flange of the engine on which the transmission and/or clutch bell housing attaches.
The 1995 Ford F150 came with four engine options and five trim levels. The curb weight for the 1995 F150 is 4,196 pounds.
Instructions are in the box the starter came with or go to the manufacturers web site. Not a fun job unless you've done them before & have access to wiring diagrams
no
check your starter or starter relay.
im looking for a wire diagram for f150 starter i am connecting
no
There are a few transmission fluids that can be used in a 1995 Ford F150. The most common fluid used would be Mercon ATF,