answersLogoWhite

0

Run a compression test. If only one cylinder has low compression, it's probably a damaged valve or pushrod. If the compression is low in all cylinders the cam is probably not timed correctly.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

What were the power rangers in 1994?

Jason David Frank as Tommy/Green Ranger & White Ranger Amy Jo Johnson as Kimberly/Pink Ranger Walter Emmanuel Jones as Zack/Black Ranger (was replaced by Johnny Yong Bosch as Adam/Black Ranger) Austin St. John as Jason/Red Ranger (was replaced by Steve Cardenas as Rocky/Red Ranger) Thuy Trang as Trini/Yellow Ranger (was replaced by Karen Ashley as Aisha/Yellow Ranger) David Yost as Billy/Blue Ranger


What ammo replaced the black talon?

Ranger SXT.


Can a oil pump be replaced on 1994 Ford Ranger 4.0 without pulling motor?

Can the oil pump be replaced on 1994 Ford Ranger 4.0 without pulling motor?


How do you bypass anti-theft system on Ford Ranger?

How do you bypass the alarm on a 2000 Ford ranger cause I replaced the ignition


On a 2001 ford ranger the thermostat will not open?

The thermostat is done it has to be replaced.......


Where is a transmission sensor that may cause the vehicle to skip during acceleration on a 02 Ford Ranger 4.0 liter?

where is a transmission sensor that may cause an 02 ford ranger 4.0 liter to feel as though it may be skipping during acceleration?


Ford Ranger 4x4 diagram?

2000 ranger 4x4 i replaced the gem and selector switch no power to transfer case motor


How do i repair the slave cylinder on my 1988 Ford Ranger?

The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.


After you had the fuel pump replaced on your 1994 ranger fuel spills out when you fill up?

Fuel pump gasket (in tank) not replaced properly?


Is it possible to clean the oxygen sensors of a Ford Ranger XLT 1994 or should they be replaced?

As far as I know they can not be cleaned. Must be replaced.


What year was Jason lee Scott the read power ranger?

Rocky replaced him in 1994.


How do you replace shocks on 2000 ford ranger?

The shocks on a 2000 Ford Ranger are replaced by jacking the vehicle up, removing the wheels, unbolting the shock, and removing it from the vehicle. Because the vehicle is supported off the ground, the shocks are not under load and can readily be replaced.