answersLogoWhite

0


Best Answer

yes look for fletch's carbd 5.0 page

i think its www.jason_fletcher.net?

honestly it is really easy to do and is done more commonly for dedicated race cars.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you convert a fuel injected 5.0 to carburated?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

What is the proper gas to oil ratio for a 1984 Johnson 115?

If it is an oil injected, (VRO) model, add nooil to the fuel. If running without the the oil injection system, use a 50:1 fuel to oil ratio, roughly one pint of 2 cycle oil, to six gallons of fuel.


2002 Chevy blazer turns over but wont start?

check the injector, may be under the intake.


What is the psi on a 2000 Chevy truck fuel pump?

psi on a 2000 Chevy truck, place the key in the on position the fuel pressure should be between 50- 60 psi....The General Motors test for this is the pressure should NOT drop more than 6-8 psi during the first 10 secounds, if it does check you fuel lines for leakes at the filter and check the check ball in the fuel system


If you have a liter of water at 50 degrees celsius sea level You heat the water so that you apply 100000 calories About how much of the water will boil Express your answer in grams?

To raise 1000 grams of water from 50 to 100 degrees requires 50 degrees x 1000 grams of heat, so the answer is 50,000 calories. Water at 100 degrees requires an additional 550 calories to convert 1 gram fully into steam. Therefore the remaining 50,000 calories can convert 50,000/550 grams into steam. So 90.9 grams become steam, and that's the answer.


Why the engine would just shut off while driving at 50 or more miles an hour in a 1990 Dodge Caravan. I have to immediately find a safe place to pull over.?

If the engine shuts down at highway speeds I will suggest there is insufficient fuel pressure and a failing fuel pump. If all is running well at lower speeds that do not demand a large supply of fuel but the problem shows at higher speeds demanding more fuel supply this is a fuel supply problem. We had one that would vapor lock like that on hot days. the fuel line runs right along the exhaust. I'm assuming it starts back up in 15 to 20 mins. you can install a piece of sheet metal where the fuel line comes close to the exhaust

Related questions

What should the fuel pressure be for a 1998 dodge 2500 pickup with a 360 fuel injected motor?

50 psi +or-5


What was the fastest car in the 50's?

American car! I would say the 1957 fuel injected corvette


Does a 1995 V6 Toyota 4Runner have fuel injection and is it normal for it to go 50MPH up a hill?

Sure is it fuel injected..and yes it goes more than 50 MPH over a hill... I think u have no idea about 4runners as all V6 are fuel injected..the engine is 3VZFE .


What is fuel mixture for 1991 Yamaha Jet Ski?

it should be oil injected ut if its been converted to premix than its 50:1


What is the fuel pressure for a 1994 2.2 chevy cavalier?

9 to 13 LBS if it has a carburetor. For fuel injected vehicles the required pressure is a minimum of 50 psi and a max of 60 psi on the rail.


What is the proper fuel mixture for a Yamaha gp338?

Yamaha has been oil injected since they began. If you need to mix yet, run 50/1


Fuel mix ratio for citation ss 377?

Most engines after the early 70's take a 50/1 ratio,until they became injected.


What is the fuel ratio for 60 HP Yamaha motor?

The non oil injected model 60 hp Yamaha outboard requires a 50:1 ratio, one pint of 2 cycle oil, to six gallons of fuel.


How do you convert 50 percent to a decimal?

To convert 50% to decimal divide by 100: 50% ÷ 100 = 0.5


What is fuel mix for a mercury 70hp two stroke?

A new Merc runs double oil for the first 10 hrs (25:1) If it is oil injected (most likely) put 50:1 in the tank and check that the oil res is actually going down. (injection working). Then just use PULP in the tank from then on. If it is not oil injected run 50:1 All Merc/Mariners run 50:1


Why does your 1990 civic idle so low?

How low is low. If you have the Multiport Fuel injected engine it is normal for it to idle just at 500rpm give or take 50 prm. Anythign lower and you have a problem.


What is the proper gas to oil ratio for a 1984 Johnson 115?

If it is an oil injected, (VRO) model, add nooil to the fuel. If running without the the oil injection system, use a 50:1 fuel to oil ratio, roughly one pint of 2 cycle oil, to six gallons of fuel.