If you are using polyurathane paint, using a general purpose lacquer thinner is not recommended, other than for cleaning equipment afterwards. For application, use only the correct thinners, of the same brand as the paint.
Yes, you can
On raw fibreglass, epoxy primer is necessary. On gelcoat, polyurathane paint sticks well, provided the surface is well sanded and cleaned with acetone, but pinholes and cratering can be a problem, so where a high standard is required, priming the gelcoat with epoxy is recommended.
Yes, enamel paint will go over flat paint.
you can paint over latex paint with latex enamel.
If you are using polyurathane paint, using a general purpose lacquer thinner is not recommended, other than for cleaning equipment afterwards. For application, use only the correct thinners, of the same brand as the paint.
Yes, you can
In my experience, it's impossible. The rollers are usually the yellow polyurathane or black rubber type, which cannot tolerate paint thinner or acetone without melting. Since bottom paint is oil based, you have to use those two to remove it. Not to mention the next time you move the boat on the trailer that paint will mark up the rollers again.
On raw fibreglass, epoxy primer is necessary. On gelcoat, polyurathane paint sticks well, provided the surface is well sanded and cleaned with acetone, but pinholes and cratering can be a problem, so where a high standard is required, priming the gelcoat with epoxy is recommended.
you don't you paint over it!! you don't you paint over it!!
put a cover over the over paint then you get get the two paint mixed
Yes, enamel paint will go over flat paint.
you can paint over latex paint with latex enamel.
Usually because of moisture under the finish.
Can I paint semi gloss over flat paint? Thanks!Barbara Phillips
Yes, you can.
yes