The glass pro's DO use a type of super glue, especially to fix stone chips in windshields.
From the layman's point of view this is difficult as they have special ways of sucking all the debris out of the crack and then forcing the glue in under pressure. It's not possible to do this without special machinery.
the windsheild wiper motor clutch/windlatch is broken
One can find the locations of K Mart Super Centers by using the store locator app on the official website. K Mart centers are a one stop shop for everything one would require.
The resistance of the ice was greater than the strength of your wiper linkage or AKA wiper transmission. IT is probably broke, but may just be disconnected.
There is no way to stop them from falling out, unless you want to glue them in, in which case you can't use the stems again. You can get stems which have quite tight slots or ones which have locking rings at the top, but these aren't fool proof. When one dart goes close to another, it is likely that the flight with fall out anyway.
If its not too big and depends were its at you can use JB weld. its cheap and easy. USUALLY,MOST CARS UNFORTUNATELY HAVE PLASTIC ENDS ON EACH SIDE OF RADIATOR ,OVER TIME THEY DECAY,A RADIATOR IS UNDER A LOT OF PRESSURE,AND THE TWO DON'T MIX,THIS COULD BE THE CASE.REPLACING THE RADIATOR IS THE ANSWER ,PATCHING IT ONLY BUYS YOU A LITTLE TIME .YOU MAYBE BROKE DOWN AGAIN SOONER THAN YOU THINK,LEAVING YOU STRANDED.NOT A GOOD IDEA TO PATCH IT.BUY A NEW ONE THAT'S CHEAPER THAN RUNNING IT HOT POSSIBLY CAUSING THE ENGINE TO OVERHEAT CRACKING A HEAD OR BLOWING A HEAD GASKET.THESE ARE VERY EXPENSIVE REPAIRS 10 TIMES WHAT A RADIATOR WOULD COST YOU.
you would need to go and get that fixed because the heat from the sun will expand the crack and it will just keep getting bigger.
cut the original glass out using guitar or piano string then re-glue it down with automotive glass glue (usually black)
ok before you do any thing STOP what your doing. Don't try to scratch of the super glue, if you do you will scratch the lens. so soak the glasses in hot water for an hour or two to break down the glue then get a rag and rub the glue off. if it does not work the first time and do process over again. Good Luck.
Call an auto glass service. This is not a DIY job. Well I beg to differ!All you need is to go to a windshield dealer, buy the glass, the primer, and the glue. Remove the old windshield, prime the sill,then put a 3/8 bead of glue all the way around the inside of the glass (start and stop points should be at the bottom of the windshield) then set glass in place . shimm the glass up to the right height. Roll windows down before shutting the doors or you will blow the seal out.
No, the hair will keep growing and possibly force your hands off
Call an auto glass service. This is not a DIY job. Well I beg to differ!All you need is to go to a windshield dealer, buy the glass, the primer, and the glue. Remove the old windshield, prime the sill,then put a 3/8 bead of glue all the way around the inside of the glass (start and stop points should be at the bottom of the windshield) then set glass in place . shimm the glass up to the right height. Roll windows down before shutting the doors or you will blow the seal out.
Windshield wipers are an important safety feature on cars. They stop working when their motor goes out, or when the blade is too worn out.
Have the windshield removed and retapped.
Fuse or windshield wiper motor.
your windshield wiper motor might burnt out or a fuse might burnt out
Because they are broken.
While compounds very similar to Super Glue were first developed as a surgical cement, and "gluing" a small, delicate surgical wound closed is a rare but occassional practice, this does not fall within the confines of First Aid. The superglue preparation you buy at hardware stores is not sterile, and a wound of the size a surgeon would glue closed can be better treated by more conventional methods during first response. In short, don't do it.