It maybe neutral safety switch .This switch is located around the steering column and tells the key switch the car is in park are neutral. standard trans have a switch on clutch pedal. hope this helps
Starter solenoid? Follow the + battery cable it connects to starter solenoid
You should locate and test the solenoid. Most have three connections. There is a large cable from the battery to the solenoid, from the solenoid to the starter and from the start switch to the solenoid. The power terminals to the battery and the starter are large and have large cables. The starter switch connection is much smaller. Turning the key to 'start' provides a low current voltage to the solenoid causing the solenoid relay to close and power from the battery cable to connect through to the starter. If that voltage is present then the solenoid or the wiring between the solenoid and battery or solenoid and starter is suspect. If that voltage is missing then the starter switch or solenoid feed line may have failed.
starter solenoid is on the inside of the fender twards the cab from the battery follow the positive battery cable at the end will be the solenoid
maybe on the top of the starter Follow the+ battery cable should connect to solenoid
Follow + battery cable probably on top of the starter
may be on top of the starter and replaced with same. Follow the + battery cable it will connect to the solenoid
The starter solenoid is attached to the starter. Follow the positive battery cable from the battery, it will lead you to the starter solenoid. The starter would have to be removed to replace the starter solenoid.
Assuming you are referring to the starter solenoid, the easiest way to find it is by folowing the positive battery cable from the battery. The cable goes from the battery to the solenoid and then continues from the solenoid to the starter.
Starter solenoid? Follow the + battery cable it connects to starter solenoid
Remove - battery cable Remove + battery cable from battery and starter solenoid Route new cable following original routing Connect to starter solenoid Connect to + battery terminal Connect - battery cable
starter solenoid is on the inside of the fender twards the cab from the battery follow the positive battery cable at the end will be the solenoid
You should locate and test the solenoid. Most have three connections. There is a large cable from the battery to the solenoid, from the solenoid to the starter and from the start switch to the solenoid. The power terminals to the battery and the starter are large and have large cables. The starter switch connection is much smaller. Turning the key to 'start' provides a low current voltage to the solenoid causing the solenoid relay to close and power from the battery cable to connect through to the starter. If that voltage is present then the solenoid or the wiring between the solenoid and battery or solenoid and starter is suspect. If that voltage is missing then the starter switch or solenoid feed line may have failed.
From battery to starter solenoid
The starter solenoid is mounted directly to the starter. Just follow the positive battery cable from the battery, it will lead you right to the starter solenoid.
Starter solenoid? One top of starter--follow + battery cable
It is attached to the starter, just follow the positive battery cable from the battery, it will lead you to the starter solenoid.
The positive battery cable is attached to the solenoid and the solenoid is attached to the starter itself.