0
What else can I help you with?
What is wrong when you rear abs and brake light sensor stays on in your 1995 rodeo?
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
Do you need to change the key chip if you change the ignition switch in a terrano?
The ignition switch should be separate from the ignition key/lock assembly, so I'll say no.
What makes people want to use a digital camera instead of buying a disposal camera?
Once you have a digital camera and a compatible memory chip, you can take almost countless pictures for no additional expense. As the memory chip fills up, you can upload it to a computer and then delete the files from the chip and keep taking more pictures without having to buy anything more. Disposable cameras have a limited number of pictures they can take on a strip of film. Often around 2 dozen pictures. When you have used up the film taking those few pictures, you need to buy another camera.
What is ABS light on a 2002 Jaguar x type and how to fix problem?
It means there is a malfunction in the brakes, the computer will need to be scanned and the problem repaired.
How do you replace dashboard lights in a 1995 Isuzu Rodeo?
depends on the year of the car. 1996 GL, yes. Over by the headlight switch, you can pop the plate out and move right. take out screws in the dash, most located in the vents. pop the fount of the dash out and then above the gauges you will see the lights, remove by turning the bulbs. have fun getting the dash apart!!
How do you tighten front bearing on 05 Rodeo?
Need to know which bearing and which Rodeo. There is a Isuzu Rodeo and a Holden Rodeo. Each has several bearings.
Do you need a new gasket when replacing the thermostat on a 1997 Isuzu rodeo?
yes
Where is refill plug on 2002 Isuzu axiom?
i need motor of Isuzu axiom 2002
Where is the idle control valve located on my 2002 Isuzu rodeo?
The idle control valve on a 2002 Isuzu Rodeo is typically located on or near the throttle body, which is situated on the intake manifold. To access it, you may need to remove the air intake duct and possibly some other components. It's advisable to consult a repair manual for detailed instructions and diagrams specific to your vehicle model.
Where are the spark plugs located for a 2002 Isuzu Rodeo v6?
There are 3 on each side of the engine. Once you take off the metal covers there will be a black rubber sleeve you will need to remove and they are down in there.
Where is the fuel pressure regulator on a 2002 Isuzu trooper?
need a picture of a 2002 Isuzu engine. Need to know where the fuel pressure regulator is located.
Where is the fuel pressure regulator located on a 2002 Isuzu trooper?
need a picture of a 2002 Isuzu engine. Need to know where the fuel pressure regulator is located.
Why does a 1999 Isuzu Rodeo start and then dies?
A 1999 Isuzu Rodeo that starts and then dies is not getting enough fuel, or the fuel mixture is off. It could be a clogged fuel line, dirty fuel filter or the fuel pump. It will need to be serviced.
Will a 98 automatic transmission work in a 99 Isuzu rodeo?
A 1998 automatic transmission may not work very well on a 1999 Isuzu Rodeo. This is mainly due to the incompatibility of the two engine systems and some modifications may need to be made.Ê
In a 2000 Isuzu Rodeo why would the check trans light blink?
My check engine light has been on for one month but last night my check trans light flashed off and on about 3miles till I was home. Why and what do I need to do? I have a 2000 Isuzu rodeo.
What would cause a 1999 Isuzu rodeo to stop running?
Some causes for a 1999 Isuzu Rodeo to stop running include a lack of fuel, a bad battery, or defective spark plugs. There can also be a combination of issues which would need to be diagnosed by a mechanic.
Where is the a c dual pressure switch located on a 2002 Isuzu rodeo?
The A/C dual pressure switch on a 2002 Isuzu Rodeo is typically located on the receiver/drier assembly, which is situated near the front of the engine bay, close to the condenser. It can also sometimes be found on the A/C line near the compressor. To access the switch, you may need to remove some components for better visibility. Always ensure the system is properly evacuated before attempting any repairs.
