0
What else can I help you with?
89 Pathfinder turns over but wont start Smells of gas and ignites out of air filter housing when stopping turning it over?
Incorrect firing order, spark timing, cam timing, or intake valve operation.
What do you do when your 1989 Buick LeSabre 3800 either idles too fast or too slow and sometimes wont start or stalls?
There could be many reasons including the spark plugs may be worn or not gapped properly if the car does not idle right, faulty spark plug wires, vacuum leaks, incorrect ignition timing, incorrect compression ratio. The culprit could also be the EGR valve or plugged PCV valve, fuel pump not delivering fuel properly, timing chain worn. I would suggest get the car check out.
Why does the engine bog after a rebuild?
What car and engine? How is valve and ignition timing?, fuel pressure, etc?
Where are the timing marks for a vauxhall Astra 1.6 8 valve s reg?
The timing marks, on your 1.6 liter engine, can be found on the front of the main pulley. The timing marks will be scattered around the outside of the pulley.
Why does car turn over then stops like its jammed just had new timing belt?
If a new timing belt was installed but the valve timing does not correspond with the pistons ie: the valves opening as the pistons reaching top dead centre ,,then it will be jamming.. bending valves and possibly damaging pistons.. when fitting a new timing belt or chain you have to be very careful of cam/valve position in respect of the pistons
What are the valve clearances 1976 Nissan RD8?
clearances valve nissan rd8
What are the valve clearances for 1984 trx 200 Honda?
the valve clearances is 3000 of a ince
In a four-stroke engine the timing gears control?
The gears keep the cam timing in sequence with the crankshaft. So the valves open when their suppose to and no damage occurs from valve to piston clearances.
In a four stroke engine the timing gears control?
The gears keep the cam timing in sequence with the crankshaft. So the valves open when their suppose to and no damage occurs from valve to piston clearances.
What are the valve clearances on an Suzuki GS750?
0.10mm
Valve clearances for Mitsubishi 4d33 engine?
Valve clearances for the Mitsubishi 4D33 engine are typically set at 0.25mm for both the intake and exhaust valves. It is important to follow the manufacturer's specifications precisely when adjusting valve clearances to ensure optimal engine performance and longevity. Regular maintenance and adjustment of valve clearances are crucial to prevent issues such as poor engine performance, excessive wear, and potential valve damage.
What is the Nissan td27 valve clearances?
valve clearance Nissan d 27
What is valve clearance o engine 4bd1 Isuzu?
Valve clearances 4bd1
What is the valve clearances for a Honda fourtrax 400?
.006
What happens if engine timing incorrect in Mitsubishi Lancer 2000?
That will depend on how far out the timing is. If it's one or two degrees, it will probably not be very noticeable, maybe burning more fuel than normal, a little less available power on hills. The more incorrect the timing is will increase the noticability of the problem. It also depends on whether you mean the valve timing or the ignition timing as they are two separate entities. If the valve timing is incorrect the motor may misfire or not run at all. There are too many variables to give a complete answer, without more info.
What are the valve clearances on the Mitsubishi 4d36 diesel engine?
What is the valve adjustment mistubishi 4d36
What is the Valve clearance 450 Yamaha grizzly?
What are the valve clearances on a 2001 Yamaha grizzly 600?
