If you don't have the owners manual for your vehicle which would tell you, just add oil until it reads full on the dipstick. Don't forget to run the engine to fill the oil filter then check it again after a few minutes. Record the amount you put in so you won't have to repeat the proccess again.
Well, basically the engine will have no lubrication and the pistons and rods will freeze in place, called seizing, and the entire engine will be a paperweight for the rest of eternity. Hope that answers your question!
Changing the oil wont keep the car from starting. Changine the plugs will if you didn't put the wires back on in the proper location. The oil light will come on until the car starts and allows the oil pump to fill the filter and circulate the oil. Once started, the light should go out.
Go to your local car store and look in the section where they have oil filters. They should have a book where you can look up your car model and match it with the type of oil filter you should put on your car. If they do not have a book in the open for customers to look up themselves, just locate the nearest employee and ask them for help.
If you have kept regular oil changes, no prep is required. Just go and put the synthetic oil in.
Do it yourself its easy. Put the front of your car on some car ramps, drain the oil, and take the whole pain off, take all the screws out and out comes the pain. Clean it with some kind of cleaner, for example carbuerator cleaner, where the gasket goes, let it dry and install the new gasket.
Yes, a person can put to much oil in a car. It usually will not hurt a car, but the excess oil can cause smoking if it gets on the motor.
Depends on what car which you fail to list.
That would depend on the make and model of the car.
Remove oil from pan or go for an oil change. Too much oil can blow out the gaskets.
where do you put transmission oil in a standard car?
you put too much oil in, it is burning the oil.
Add 1 quart. Check your oil stick, and go from there.
Put more oil in it.
what kind of hyderlic oil i have to put in jack
Yes, a person can put oil down the dipstick shaft. However it is not advised to do so, because they cannot properly keep track of how much oil is being put in, and too much oil can damage the car.
It is important to know how much oil to put back in a car, when changing the oil or oil filter of a vehicle. In a Toyota Tacoma 4x4 4.0 L it usually takes 4.5 to 5 quarts of oil.
It'll be above the full mark on the dipstick.