Well, .. for a 1994 Lumina APV - here's what I did: I replaced the starter in my 1994 Lumina APV (3.8 L V6) after about 120,000 miles. Symptom was that the starter would turn over very slowly when the engine was hot. Nice gentleman @ Autozone told me that the coils tend to deteriorate and heat conducted from the engine causes the starter to heat up and then draw high current when hot. Cold starts were fine - hot starts caused the starter to turn very slowly (like the battery was drained). He tested the starter and it tripped the breaker on the tester two (2) times.
Got a remanufactured one for ~$65.
Here's what I did.
1) Disconnect cable from negative battery terminal
2) Raise vehicle front and suitably and safely support.
3) Remove cover from starter wiring (small right angle-like black plastic cover).
3) Loosen large wiring harness (underneath starter) so that it can be moved out of the way.
4) Remove outer nut and wires from solenoid.
5) Remove outer nut and wires wires from starter.
6) Remove two (2) screws retaining plastic flywheel cover and cover. You will need to do this - otherwise you will be unable to remove the front bolt holding the starter to the engine block. This cover is a small black plstic piece located where starter penertates the flywheel cover.
7) Remove (2) bolts retaining starter to the engine block. One is accessable towards the front of the starter/vehicile and the other (long one) is towards the rear of the vehicle - just behind the frame cross member.
8) Position starter so that if can be dropped down (flywheel gear part first).
9) Reverse the above instructions to install the new starter/solenoid.
Palmboy (6/25/05)
Starter solenoid? Follow the + battery cable it connects to starter solenoid
TAke it to auto zone and have them chack it out
how to change starter on Hyundai scoupe 1993 12 valve
Disconnect the - battery cable Raise and support vehicle Disconnect wiring harness at starter Remove starter mounting bolts Remove starter
It's located on the end if the main power wire coming off the alternator. This wire connects to the starter. The fusible link is located on the starter end of the wire.
it is located on top of starter! it is a starter solenoid,on v6
With great care.
Remove the positive battery cable from your 2000 Chevy Malibu battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
where is the Starter on a 2006 Malibu Maxx LT
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU
How do you replace a cigarette lighter in a 1999 Malibu
Above starter below Exhaust manifold
Remove the positive cable from your 1999 Chevy battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Remove the belt from your 1999 Chevrolet Malibu alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining nuts. Reverse the process to change to the new alternator.
The cost to replace a starter in a Malibu will depend on the labor costs and also the year of the vehicle. The prices for the starter start at $38.00.
if its an automatic change fluid filter in transmission!!
depends on where you get it! I am in nys and I can get a one for 150.00 plus core! at auto zone.....