Well, .. for a 1994 Lumina APV - here's what I did: I replaced the starter in my 1994 Lumina APV (3.8 L V6) after about 120,000 miles. Symptom was that the starter would turn over very slowly when the engine was hot. Nice gentleman @ Autozone told me that the coils tend to deteriorate and heat conducted from the engine causes the starter to heat up and then draw high current when hot. Cold starts were fine - hot starts caused the starter to turn very slowly (like the battery was drained). He tested the starter and it tripped the breaker on the tester two (2) times.
Got a remanufactured one for ~$65.
Here's what I did.
1) Disconnect cable from negative battery terminal
2) Raise vehicle front and suitably and safely support.
3) Remove cover from starter wiring (small right angle-like black plastic cover).
3) Loosen large wiring harness (underneath starter) so that it can be moved out of the way.
4) Remove outer nut and wires from solenoid.
5) Remove outer nut and wires wires from starter.
6) Remove two (2) screws retaining plastic flywheel cover and cover. You will need to do this - otherwise you will be unable to remove the front bolt holding the starter to the engine block. This cover is a small black plstic piece located where starter penertates the flywheel cover.
7) Remove (2) bolts retaining starter to the engine block. One is accessable towards the front of the starter/vehicile and the other (long one) is towards the rear of the vehicle - just behind the frame cross member.
8) Position starter so that if can be dropped down (flywheel gear part first).
9) Reverse the above instructions to install the new starter/solenoid.
Palmboy (6/25/05)
Wiki User
∙ 8y agoWiki User
∙ 17y agoThe best way to find out is to go to your local auto parts store, ask for a chiltons or haynes manual for your car. These manuals tell you everything you need to know about your car. The starter is located in the front of the engine under the exhaust manifold. First you need to disconnect the 2 electrical wires connected to the starter solenoid, which is mounted to the starter. There are 2 bolts holding the starter on. The bolts go up through the bottom. Once the starter is removed, you might have to transfer the solenoid over to the new starter.
Wiki User
∙ 17y agoAfter disconnecting the battery, disconnect the electrical connection on the starter solenoid. remove the starter bolts and the starter. Note the location of the spacer shim. Installation is the reversand make sure you replace the shim or you will get noise.
Wiki User
∙ 14y agoIt would be best if you went to a bookstore or parts house and bought a Haynes Manual. They make them for you specific car. There will be plenty of useful information that you will be able to use.
Wiki User
∙ 14y agocheck for a cylinder shaped object towards the bottom of the motor on the passenger side...see it? should have three bolts holding it flush to the motor...disconnect the battery...unbolt the three bolts and unplug the wire from the starter(cylinder shaped object)...don't forget any auto parts store will buy back your old starter(they get refurbished)
Wiki User
∙ 17y agohow do u replace the starter on a 95 chev lumina?
Wiki User
∙ 17y agounbolt neg battery cable, remove wires from starter solenoid, unbolt starter 45 min job
Starter solenoid? Follow the + battery cable it connects to starter solenoid
TAke it to auto zone and have them chack it out
how to change starter on Hyundai scoupe 1993 12 valve
Disconnect the - battery cable Raise and support vehicle Disconnect wiring harness at starter Remove starter mounting bolts Remove starter
Look at lower rear of engine
it is located on top of starter! it is a starter solenoid,on v6
With great care.
Remove the positive battery cable from your 2000 Chevy Malibu battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
where is the Starter on a 2006 Malibu Maxx LT
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU
How do you replace a cigarette lighter in a 1999 Malibu
Above starter below Exhaust manifold
Remove the positive cable from your 1999 Chevy battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Remove the belt from your 1999 Chevrolet Malibu alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining nuts. Reverse the process to change to the new alternator.
The cost to replace a starter in a Malibu will depend on the labor costs and also the year of the vehicle. The prices for the starter start at $38.00.
if its an automatic change fluid filter in transmission!!
My 1999 Malibu holds only 10 gallons. My 1999 Malibu holds only 10 gallons.