answersLogoWhite

0

replacing the starter is relatively simple, what do is remove the wires from the starter solenoid which is located on top of the starter motor, and mark where the wires came from, there is a small terminal then there is a bigger terminal. oh and un hook the battery before that because it's an unpleastant surprise. then using a jack support the starter before the bolts are removed, then remove the bolts, which in most cases are 15mm, then lower the jack with the starter and put the new one one the jack. raise the jack and hook everything back up. get the starter secured and hook the wires up then the battery and turn it over. jeremy aka ccz5105

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Where is the starter located on a 1993 buick century v6 3300?

The starter and solenoid are mounted together on the bottom front side of the engine


Replace ignition switch for 1993 Buick century?

Replace ignition switch for 1993 buick century?


How do you change a starter on a 1993 buick century v6 3300?

well first you make sure your car is off. then u take the wires of and undo the bolts then replace it with a new one and the work backwards.


Does a 1993 buick century have a timing belt or timing chain?

where is the timing chain on a 1993 buick century 3.3


Where is a starter located on a 1993 Buick Century?

Bottom of your engine compartment, front side. Make sure you disconnect the battery befor you try working on it, or around it.


Where is the starter at on a 1993 Buick Le Sabre?

At the lower rear end of the engine


Where is the water pump located on a 1993 Buick Century?

Britain


Where is the horn on a 1993 Century Buick?

Center of the steering wheel.


What is the spark plug gap for a 1993 Buick Century?

The spark plug gap for a 1993 Buick Century is: .045 for the 4 cyl 2.2 engine .060 for the V6 3.3 engine


How do you change the starter on a 1993 525i BMW?

how do you change the starter on 93 525i BMW


Where is the starter relay switch on a 1993 Buick Regal with a 3800 series engine?

I believe yours has a starter mounted solenoid and not a relay.


How do you remove a starter from a 1993 Buick Roadmaster with a 350 engine?

To remove the starter from a 1993 Buick Roadmaster with a 350 engine, first disconnect the negative battery cable to ensure safety. Then, locate the starter, which is positioned on the passenger side of the engine. Remove the electrical connections and the mounting bolts securing the starter to the engine block. Finally, carefully slide the starter out from its position.