First mark the drive shaft location at both ends. Remove the bolts holding the U-Joint together and drop the driveshaft. The U-joints are installed and glued at the factory to the rear end and yoke of the drive shaft. Heating the end caps with a torch will force the glue out of the side weep holes where it was injected. Clean well and install new U-Joint and expansion clips provided. Reinsall Drive Shaft to markings.
The collectr and all applicable o rings
Ignition control module.. located under the distributor The distributor cap is probably cracked and moisture is getting into it. Replace the cap .
Dexron III is the correct fluid for this application
try looking on the www.blazerforum.com
need to be more specific. what model chevy?
a 4 door 97 blazer front how do i do it
The 1997 Chevrolet Blazer didn't come with a cabin filter.
how to replace a heater core in a 1997 Chevy blazer
1995-1997
Will a 1997 blazer what work on a 1999 blazer????? If your talking engine, transmission, or running gear than yes. It is all the same.
The 4.3 liter V6 engine in a 1997 Chevy Blazer has a timing CHAIN
Remove the positive battery cable from your 1997 Chevy Blazer battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
hire someone that knows how thats what im doing
I have a 1997 Chevy Blazer 4DR and the relay is located underneath the glove box.
buying a chilton or haynes repair manuel for the s series blazer will help in knowing how to change it
Freon is R12. Your 1997 Chevy uses R134 Refrigerant.
Same as a 96 blazer go here.How_do_you_replace_the_blower_motor_on_a_1996_Chevy_blazer