0
How do you deactivate the seat belt minder in a 2004 ford escape?
Wiki User
∙ 14y ago
here you go try going here first www.ebookspdf.com/automotives/3189/Ford-escape-2001-owners-manual/
and if that doesnt work try what i did get in like ur going somewhere without ur seat belt on put ur key in to the on position but dont turn it on wait till the seat belt light goes off then pull ur seat belt in and out 3 times then real fast turn ur light on then off then real fast pull ur seat belt in and out again 3 times then in 5 sec. pull it back in and out then the seat belt light should flash 4 times or so if u done it right hope this help.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
When should timing belt be changed on a rover 75 1.8 petrol 2004?
i have a rover 75, 1.8. it has about 26,000 miles on clock. when does my timing belt need changing
How do you disable the seat belt buzzer on a ford van?
Splice into the seat belt wires. + - wires. Run the wires around to your dash board. connect a 100 ohm resister to a switch as if to be parallel with the seat belt circuit. when you flip the switch the car thinks your seat belt is fastened. The only problem when you actually want to put on your seat belt then you get some error message on the dash. So, flip the switch off then fasten your seat belt. Then your set to go. -Check to see if there is a plug on the bottom of the seat belt harness and try that... don't know if it will work but a good idea to start with... always try asking a junk yard too. they tear them apart and should know what does what.
Does the 2004 gm envoy have a timing chain or belt?
In a 2004 GMC Envoy both the 4.2 liter six cylinder and the 5.3 liter V8 engines use a timing CHAIN
How do you deactivate the seat belt chime in the 2007 Aston Martin Vantage?
I found your question because I was searching for the answer myself!! I am trying to deactivate the chime on my DB9 - and sent it back to Aston Martin to ask them to do it. They refused. The dealer I bought it from is looking in to having it removed 'privately' on the qt. Meanwhile I am going to write to Aston to moan like bloody mad about how annoying it is that I can't even reverse down my drive without ding... ding... ding... ding... in my ear. Please do the same!
What is the serpentine belt routing for a 2004 dodge ram 3500 5.9L cummins turbo diesel with ac?
http://www.thedieselgarage.com/forums/showthread.php?t=52035
How do you deactivate the seat belt minder on a 2005 Ford F-150 truck?
Found the procedure to "Deactivate" the Seat Belt Minder, On pages 135-136 of the On-line Owners Manual. Here's the URL https://myford.fordvehicles.com/
Does the 2004 Ford Escape have a timing belt or chain?
The 2.0 liter DOHC , Zetec engine in a 2004 Ford Escape has a timing BELT
What fuse controls the seatbelt alarm on a 2005 Ford Escape?
Instaed of messing with the fuse, you can temporarily or permanently disable the seat belt alarm. Below is s copied instruction from a website on how to do it. Just remember all is at your own risk. You can Deactivate the Belt Minder two ways. First, you can deactivate it temporarily for your current "run cycle", that is after you have started your car and it's still running. Second, you completely deactivate the Belt Minder so that it never reminds you again, or at least until your reactivate it... The first method, temporary deactivation, or one time disable: After you have started your vehicle, buckle and then un-buckle your safety belt. Be sure to buckle back up.... This will disable the Belt Minder only for that ignition cycle. The second method, permanent deactivation: There are 9 steps you need to follow to deactivate or activate your Belt Minder system. Before doing so, make sure that: The parking brake is set. The truck/car is in Park (automatic), Neutral (manual). The ignition is OFF. All doors are closed. The driver's safety belt is un-buckled. The parking and headlights are OFF. Then follow these 9 steps: Turn the ignition switch to ON, but DO NOT START. Wait for the safety belt warning light to go OFF(1-2 minutes). Steps 3-5 MUST be completed within 60 seconds! Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled. Turn on the headlights, turn off the headlights. Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled. After step 5, the Safety Belt Warning Light will be turned on for 3 seconds. Within 7 seconds of the safety belt warning light turning OFF, buckle then un-buckle the safety belt. This will disable the Belt Minder if it is currently enabled, or enable the Belt Minder if it is currently disabled. Confirmation of the disabling of the Belt Minder is provided by flashing the safety belt warning light 4 times per seconds for 3 seconds. Confirmation of the enabling of the Belt Minder is provided by flashing the safety belt warning light 4 times per seconds for 3 seconds, followed by 3 seconds with the safety belt light off, then followed by flashing the safety belt light 4 times per second for 3 seconds again. After confirmation, the deactivation/activation of the Belt Minder procedure is complete
What Fuse disarms the seatbelt warning alarm on a 2007 Ford Tarus?
You can Deactivate the Belt Minder two ways. First, you can deactivate it temporarily for your current "run cycle", that is after you have started your car and it's still running. Second, you completely deactivate the Belt Minder so that it never reminds you again, or at least until your reactivate it... The first method, temporary deactivation, or one time disable: After you have started your vehicle, buckle and then un-buckle your safety belt. Be sure to buckle back up.... This will disable the Belt Minder only for that ignition cycle. The second method, permanent deactivation: There are 9 steps you need to follow to deactivate or activate your Belt Minder system. Before doing so, make sure that: The parking brake is set. The truck/car is in Park (automatic), Neutral (manual). The ignition is OFF. All doors are closed. The driver's safety belt is un-buckled. The parking and headlights are OFF. Then follow these 9 steps: Turn the ignition switch to ON, but DO NOT START. Wait for the safety belt warning light to go OFF(1-2 minutes). Steps 3-5 MUST be completed within 60 seconds! Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled. Turn on the headlights, turn off the headlights. Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled. After step 5, the Safety Belt Warning Light will be turned on for 3 seconds. Within 7 seconds of the safety belt warning light turning OFF, buckle then un-buckle the safety belt. This will disable the Belt Minder if it is currently enabled, or enable the Belt Minder if it is currently disabled. Confirmation of the disabling of the Belt Minder is provided by flashing the safety belt warning light 4 times per seconds for 3 seconds. Confirmation of the enabling of the Belt Minder is provided by flashing the safety belt warning light 4 times per seconds for 3 seconds, followed by 3 seconds with the safety belt light off, then followed by flashing the safety belt light 4 times per second for 3 seconds again. After confirmation, the deactivation/activation of the Belt Minder procedure is complete.
How do you disable the seat belt buzzer on a 2006 Ford Escape?
I just bougt the 2007 model and found a website that allows you to permanently or temp. disable the alarm. Hope this helps, because it was annoying the hell outta me, and as the site site, use at your own risk. You can Deactivate the Belt Minder two ways. First, you can deactivate it temporarily for your current "run cycle", that is after you have started your car and it's still running. Second, you completely deactivate the Belt Minder so that it never reminds you again, or at least until your reactivate it... The first method, temporary deactivation, or one time disable: After you have started your vehicle, buckle and then un-buckle your safety belt. Be sure to buckle back up.... This will disable the Belt Minder only for that ignition cycle. The second method, permanent deactivation: There are 9 steps you need to follow to deactivate or activate your Belt Minder system. Before doing so, make sure that: The parking brake is set. The truck/car is in Park (automatic), Neutral (manual). The ignition is OFF. All doors are closed. The driver's safety belt is un-buckled. The parking and headlights are OFF. Then follow these 9 steps: Turn the ignition switch to ON, but DO NOT START. Wait for the safety belt warning light to go OFF(1-2 minutes). Steps 3-5 MUST be completed within 60 seconds! Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled. Turn on the headlights, turn off the headlights. Buckle, then un-buckle the driver's safety belt 3 times, ending with the belt un-buckled. After step 5, the Safety Belt Warning Light will be turned on for 3 seconds. Within 7 seconds of the safety belt warning light turning OFF, buckle then un-buckle the safety belt. This will disable the Belt Minder if it is currently enabled, or enable the Belt Minder if it is currently disabled. Confirmation of the disabling of the Belt Minder is provided by flashing the safety belt warning light 4 times per seconds for 3 seconds. Confirmation of the enabling of the Belt Minder is provided by flashing the safety belt warning light 4 times per seconds for 3 seconds, followed by 3 seconds with the safety belt light off, then followed by flashing the safety belt light 4 times per second for 3 seconds again. After confirmation, the deactivation/activation of the Belt Minder procedure is complete
Does a 2004 Ford Escape V6 have a timing belt or chain?
chain(s)
Diagram for a 2004 Ford Escape serpentine belt?
The diagram is similar to a Ford Focus. This applies to a 2.0L Escape 2004. http://www.fixya.com/uploads/Images/A4E447B.jpg Ford stuck a diagram on the front fender of the Escape 2004 but it was incorrect.
Does a 2004 ford escape have a timing belt for the 3.0 liter engine?
timing CHAIN
How do you deactivate the seat belt chime in a 2007 Impala?
Put your seat belt on:)
Deactivate seat belt alarm 2007 Mitsubishi outlander?
You cannot deactivate the seat belt alarm. It is installed to keep all riders in the vehicle safe.
Can you unhook the sensors for seat belt in Dodge Caliber?
Check in your owners manual for instructions to deactivate the active seat belt alert systemCheck in your owners manual for instructions to deactivate the active seat belt alert system
When do you change the timing belt on a Ford Escape 2004?
120,000 miles for the 2.0 liter 4 cylinder in a 2004 Ford Escape ( according to the Gates website and the Ford maintenance guide )
