How do you disable the seat belt buzzer on a ford van?

Answer 1

Splice into the seat belt wires. + - wires.

Run the wires around to your dash board. connect a 100 ohm resister to a switch as if to be parallel with the seat belt circuit. when you flip the switch the car thinks your seat belt is fastened.

The only problem when you actually want to put on your seat belt then you get some error message on the dash. So, flip the switch off then fasten your seat belt. Then your set to go.

-Check to see if there is a plug on the bottom of the seat belt harness and try that... don't know if it will work but a good idea to start with...

always try asking a junk yard too. they tear them apart and should know what does what.

Answer 2

Preparation
NOTE: The driver and front passenger belt minder are deactivated/activated independently. When deactivating/activating one seating position, do not buckle the other position as this terminates the process.
[ol][*]Before deactivating/activating the belt minder, set the parking brake.[/ol][*]Place the transmission selector lever in PARK (P).
[ol][/ol][*]Turn the ignition switch to the OFF position.
[ol][/ol][*]Unbuckle the driver and front passenger safety belts.
[ol][/ol]
Deactivating/Activating
[ol][*]Turn the ignition switch to the ON position (do not start the engine).[/ol][*]Wait approximately 1 minute until the safety belt warning indicator turns off.
[ol][/ol][*]
NOTE: Step 3 must be completed within 50 seconds after the safety belt warning indicator turns off.To disable the seating position, buckle then unbuckle the safety belt 9 times, ending in the unbuckled state.[*]After Step 3, the air bag warning indicator illuminates for 3 seconds.
[ul][/ul]
[ol][/ol][*]Within 10 seconds of the indicator turning on, buckle then unbuckle the safety belt.[*]This disables the belt minder feature for that seating position, if it is currently enabled. As confirmation, the air bag warning indicator flashes 4 times per second for 3 seconds.
[ul][/ul][*]This enables the belt minder feature for that seating position, if it is currently disabled. As confirmation, the air bag warning indicator flashes 4 times per second for 3 seconds, followed by 3 seconds with the light off, then followed by the air bag warning indicator flashing 4 times per second for 3 seconds again.

Answer 3

1. Turn ignition to Run (do not start) (seatbelt unbuckled) 2. Wait for the seatbelt light to turn off ( 1 to 2 minutes) 3. Buckle and unbuckle seatbelt 9 times 4. the seat belt light will come on for 3 seconds 5. when light goes off buckle and unbuckle seat belt 6. the light will blink and go off All Done Remember you will have to do this for both front seats.

Answer 4

Escape seatbelt alarm can be disabled by removing the seatbelt alarm fuse. This will disable the alarm, but it is not recommended to operate the vehicle this way.

Answer 5

Check owner's manual. If you don't have one copy and paste link below; www.fleet.ford.com/maintenance/owners_manuals

Answer 6

cut the wire to the buzzer

Answer 7

Disable the seat belt alarm in a e250

Answer 8

Buckle up.