Should be at the lower end of the engine follow the + battery cable
its probbaly the starter. i have a 1993 and mine went bad. check all the wires and tighten everything that's loose and if that dosent work put a screw driver across the terminals on the starter and if it dosent turn over then the starter is bad
On a 1990 Chrysler New Yorker, the starter relay is built into the starter. The starter is located on the front of the engine, behind the engine mount.
if u are facing your truck it will be on the left side of the engine!! u can take the bottom bolt off from the bottom but the top bolt well your gunna have to take it off from the top your gunna have to open your hood and slide your hand down to the starter! good luck...
Probably not.
29s here, i work for an automotive company a recently we had a 94 or 95 caddy deville with the north star engine in for a starter replacement. the starter was located in the center of the motor! the engine is a v-shape (v8) with the intake cover acting as a lid overtop of the motor with the starter smack in the center. you would have to remove the intake in order to even see the starter if you have the same motor types. That is exactly how to remove it on a 97, i have one and the starter is located under the intake.
Nissan Primera was created in 1990.
Nissan Primera cars were launched in Japan in 1995, although the first model was ready in Sunderland in 1990. The Nissan Primera car replaced Nissans 'Bluebird'.
set then at least 35-40mm
At the back of the engine there is a container you pour it into.
For the gearbox or engine? and there both in the engine bay.
The Primera was a family-size car manufactured by the Japanese company Nissan. It was made in Sunderland, UK from 1990 to 2006 and was last produced in Japan in 2008.
On the underside, passenger side, of the transmission.
hey there thanks for any help, just bought a nissan primera 1990, both radiator fans dont work and im told the sensor may need changing, does anyone know where i can locate it to replace?
Look at the lower rear end of the engine
put up on car jacks or on host use 14mm wrench (sockets are a tight fit)then some patients after u get the motor unmounted then tackle the ground and power wires, wiggle the starter out and that`s that`s...
passenger side above the rack
It's above the starter near the oil filter.