On a 1990 Chrysler New Yorker, the starter relay is built into the starter. The starter is located on the front of the engine, behind the engine mount.
If the Chrysler Sebring won't start after going through a puddle, the problem is probably that the starter relay switch got wet. This is not a common thing but if the starter relay was bad to begin with, moisture will make the problem worse. The starter relay is located on the starter.
Should be on top of the starter
If it is like my '86 Samurai there is no starter relay. It uses a starter solenoid on the top of the starter to pass battery to starter motor when the solenoid is activated via the key switch.
Maybe on the top of the starter - follow the + battery cable it will connect to the starter relay (solenoid)
If it is a automatic transmission there is no starter relay but, an ignition relay instead. If it is manual the starter relay is located under the hood at the fuse box on the left (drivers) side.
What relay? None found in service manuals
remove glove box
location of the starter relay 1995 mirage
There is a relay box just behind the battery ...
It is in the under hood fuse panel, next to the battery. Lid should show location.
starter relay location
The relay is in the fuse box under the hood.
Indirectly, the starter relay is computer controled.
On top of starter
Your relay sensor is likely faulty
It is inside the under hood fuse box.
The relay is attached to the starter and is an integral part.