Heater core.
There is no fixing a broken motor mount. Replace them with a new ones.
It is a Philips 2040 Halogen bulb. Expensive too..About $9 each.
Hard job requiring refrigerant recovery system. TAke it to a garage.
It's been a few years since I sold mine, but it should be under the glove behind the kick panel...
most likely it is your fuel pump the same thing happened to my 1999 mercuy sable
2.6 gallons
According to the 1996 Mercury Sable owners manual :It came from the factory with a 50 / 50 mix of distilled water and GREENcolor antifreeze ( meeting Ford specification ESE-M97B44-A )
According to the 1999 Mercury Sable Owner Guide : It came from the factory with a 50 / 50 mix of distilled water and GREEN color antifreeze ( meeting Ford specification ESE-M97B44-A )
Leaking?Wobble in pulley?
According to the 2001 Mercury Sable Owner Guide : For the " Vulcan " and " Duratec " 3.0 litre V6 engines : They came from the factory with a 50 / 50 mix of distilled water and GREEN colored antifreeze ( meeting Ford specification ESE-M97B44-A )
For a 2001 Mercury Sable, the cooling system typically requires about 2 to 2.5 gallons of a 50/50 mixture of antifreeze and water. It's important to check the owner's manual for the exact specifications and to ensure proper mixture ratios for optimal performance. Always make sure to use the appropriate type of antifreeze recommended for your vehicle.
Green color antifreeze meeting Ford specification ESE-M97B44-A ( it came from the factory with a 50 / 50 mix of distilled water and the GREEN color antifreeze )
According to the 2001 Mercury Sable Owner Guide : It came from the factory with a 50 / 50 mix of distilled water and GREEN color antifreeze ( meeting Ford specification ESE-M97B44-A )
If the fluid is GREEN in color and you mean near the passenger side front tire it sounds like it could be engine coolant ( usually a 50 / 50 mix of antifreeze and distilled water )
Mercury Sable was created in 1986.
For a 2003 Mercury Sable, it is recommended to use a low silicate, ethylene glycol-based antifreeze that meets Ford's specifications. The preferred type is a 50/50 mix of antifreeze and distilled water, typically in the form of a coolant labeled as "Ford Motorcraft" or another compatible brand. Always check the owner's manual for specific recommendations and capacity information before refilling or replacing the coolant.
mercury sable