You can try drying it with a hair blow dryer. If that does not work then heat your oven to 150 degrees and leave it in there overnight. If that does not work you will need to replace it.
The ignition (spark plugs, wires, cap and rotor) may have been wet or the firing order is mixed up.
Wet Wet Wet are a Scottish pop rock band that formed in the 1980s.
True, it does! There is also a technique in water colour where paint is added to a wet surface. This is also referred to as "wet on wet".
wet on wet mean's that you are applying wet paint(usally Artist's oil colour's) on top of wet paint and making it stick together without mixing into "mud", remember the "golden rule",thin sticks to thick.
"Wet on wet" or "wet in wet" means that you are applying wet paint (usually oil, artist's colours) to a surface that you have already painted which is still wet. If using oil, then your surface would be oil based, such as linseed oil or turpentine. This technique enables you to move and blend the paint to finish a painting in one sitting. "Wet on dry" means you are applying wet paint to a dry surface that you have painted earlier and allowed to dry. You can do this to either build up an area, or as in glazing, to achieve certain effects.
Fix a wet area on yard
that is very extrange situation but i got the anwer for you. i am land rover tech and i like to help. ok do this take a water hose and start the car, spray water to the crank sensor, ( the crank sensor is located on the left side of the engine next to the cat) if the car stall that doesnt mean that the crank sensor is bad, since the problen ocour on wet weather and if you do what i said so that meas that water goes inside of the crank connection or cable. so check the wires and i bet that youll find something there. if you do just put some insulation tape one wires and youre done, if that cures the problem send me an email just to know that i helped you. snooker1813@yahoo.com.
Blow dry it.
the sensor is normally sealed i.e. it is water proof, so there is no way of water getting inside. and if it gets wet, the sensor blows up n it stops functioning
Dry it
Ignition wires, cap and rotor may have gotten wet. Fuel pump failure. Crank sensor failure. Contaminated fuel (water).
if it just got wet leave it in a bag of uncooked rice overnight. It should work :)
Once they get wet, the only way to fix it is to replace the damaged areas.
Tes. You can fix a wet iPod. You schould probably leave the screen of the iPod on a hot surface such as a cable box. You should leave it there for about 2-3 days. Hope this helps! :):):):):):):):):):)
it is an air contioner drain problem <its clogged> like $200+ to fix
so that your sexy vagina is wet and is ready for sexing.
bcoz a heat-fix smear have a good contrast than the wet mount