There are many ways to keep mice from eating wiring under a car hood. You could coat the wires with tape for example.
there is a fusable link in the wiring, but no actual fuse. the fusable link is down by the starter assembly...
The injectors will be fused with something else. Get a wiring diagram from MOTORLIT.COM.
I doubt very much that the wiring would interchange.
The starter is definitely under the hood. Try getting under and looking where the engine is bolted to the transmission. It will be right there.
under the hood if its not under the dash
close your hood
The diagnostic connector is along the wiring harness, under the hood, on the passenger side firewall.The diagnostic connector is along the wiring harness, under the hood, on the passenger side firewall.
it could be a fuse or a wiring problem check the fuses under the dash and under the hood and if all are fine check your wiring check all the fuses under the dash and hood and if there all good it might be wiring problem or the bulb
An under hood wiring diagram for the Dodge Ram 2500 can be found in its service manual. A copy may be obtained from the nearest Dodge dealership.
Under the hood, under the dash, in the doors, under the seats, and in the trunk. The wiring harness connects all the electrical components in the car.
No. The wiring is inside the cab.
a 1995 grand Cherokee is obd 1 compliant, The diagnostic connecter is under the hood. It is a black square connector.
It will fit under the hood, but it will not bolt to the trans, the wiring harnesses are completely different along with the cooling, ac, and computers.It will fit under the hood, but it will not bolt to the trans, the wiring harnesses are completely different along with the cooling, ac, and computers.
under the hood The wire for the horn is part of the front lights wiring harness. The relay is not under the hood. Please, if someone knows, where is the horn relay?
A 1991 Dakota is not OBD2 compliant. It is OBD1, and the diagnostic connector is under the hood on the wiring harness on the passenger side firewall.A 1991 Dakota is not OBD2 compliant. It is OBD1, and the diagnostic connector is under the hood on the wiring harness on the passenger side firewall.
For a 1971 GM pickup, the under-the-hood wiring diagram typically includes connections for the battery, starter, ignition coil, alternator, and various sensors. The wiring harness routes power to essential components like headlights, turn signals, and the engine management system. It's important to refer to a specific service manual for detailed schematics, as configurations can vary based on the engine type and options installed. You can often find wiring diagrams through classic vehicle restoration websites or automotive forums.
Yes, you can put a plug on a hardwired under-the-counter range hood, but it requires proper electrical work. This involves installing an appropriate outlet and ensuring that the range hood's wiring is compatible with the plug. However, it's essential to follow local electrical codes and possibly consult a licensed electrician to ensure safety and compliance with regulations.