remove taillights, pull taillight wires out of box from underneath. Free the gas filler from the box side. Remove the filler neck ground wire. Undo the 8 (?) box bolts from underneath (long extension with impact wrench) there will be holes to access the bolts through, but sometimes they are covered by aftermarket trailer hitches at the back. lift box
T-55 Torx Bit, unless they're been replaced before. Auto supply and hardware mega-chain stores have them.
In The Sims 3, to set bed ownership, click on the bed you want to assign to a specific Sim. Then, select the option "Set Ownership" and choose the Sim you want to own the bed. This will ensure that only that Sim can sleep in or claim the bed, while other Sims will be unable to use it without permission. If you want to remove ownership, you can repeat the process and select "Remove Ownership."
Depending on the engine: (According to Haynes Repair Manual) 3.0L - the oil pump is located in the oil pan. You'll have to remove the oil pan, then the oil pump mounting bolt. Lower and remove the oil pump assembly (the oil pump intermediate shaft will come down with the pump). 3.8L - The oil pump is mounted in the oil pump cover/oil filter adapter. The oil pump intermediate shaft is mounted to the timing chain by a clip (I have a 3.0L, so I haven't seen this). You'll have to remove the oil filter, then the oil cooler assembly. Remove the oil pump/oil filter adapter from the front cover (inspect the oil pump gear pocket). Remove the oil pan, the pickup tube bracket nut, and two mounting bolts to remove the oil pump pickup, then lower and remove the pickup. This is probably more info than you wanted, but there you go.
there is 8 bolts, 4 on each side that run up the middle of the frame, also you have 2 or 3 ground straps near the fuel tank, dont forget to undo the fuel neck......3 screws have to open the fuel door to reach them....last but not least the tail light plug.....on the driverside frame rail near the rear. P.S. better have a few buddies or a lift cause it weights about 3-4 hundred pounds
It is in the gas tank, you will have to remove fuel tank to service the pump.
Drop the fuel tank or remove the bed.
you must remove the bed its the only way
Drop the fuel tank or remove the bed.
To remove the bed of a 1992 Toyota pickup, first, ensure the vehicle is parked on a flat surface and secured. Disconnect the tailgate and any electrical connections for lights. Then, remove the bolts securing the bed to the frame, typically found at the rear and along the sides. Finally, use a hoist or a few strong helpers to carefully lift the bed off the frame.
take the bolts out id reckon
To remove the bed from a 1987 Nissan pickup, start by disconnecting the tail lights and any wiring harnesses. Then, remove the bolts securing the bed to the frame, typically found along the sides and at the rear. After all bolts are removed, lift the bed off the frame with the help of another person or a hoist. Be cautious of any remaining connections, such as fuel filler hoses, before fully separating the bed from the truck.
It may be more difficult to remove the bed than to drop the tank.
A 2005 Ford pickup bed is about 5.6 foot long. This is a normal size bed not a long bed.
it is in the tank not bad to change remove 6 bolts from bed unplug tail light slide bed back change pump and put bed back
there are 2 screws inside the bed right nere the tailgate vertical in the cornors.
Never
i drive a 1993 Nissan d21 pickup and the bed is 73in long by 55in wide