Must be removed from underneath the car. Also the cross member blocking access to the alternator must be removed. This is a very difficult repair, as I have done this one myself.
Would it be the same on a 2001 civic
Integrated into the alternator.
Wheel bolts go through a hole in the hub and are held in place by a knurl toward the head of the bolt. Search napaonline for a picture of one. To remove just take off the wheel and pound on the stud where the lug nut was. You probably have to spin the wheel until there's a place for the bolt to come out of the back of the hub.
4
The 1991 Blazer has a current draw causing the wire to burn. You will need to trace the wiring out to find what is drawing too much current.
Inside the alternator
The voltage regulator for a 1991 Honda accord is mounted on the rear of the alternator. It is bolted on and can be replaced as a separate unit.
First you have to remove the power steering pump. Then you need to remove the alternator. You might have to remove the brackets that hold the previously removed items as well.
5 minutes :>
Curb weight 2,822 lb of a 1991 Honda accord
its inside the fule tank drive safe
do 1991 honda accords have airbags?
The 1991 Honda Accord did not come equipped with a cabin filter.
where is the fuel pump relay for a 1991 Honda accord located
If you are facing the front of the vehicle the AC compressor is located on the right side of the engine, below the alternator.
yes
Remove rear seat and panel underneath seat. How do I remove rear seat?!?!