Wiki User
∙ 2015-07-15 19:57:45do you have the key!!!! remove the steering wheel covers turn the key to run there should be a little brass pin under the lock cyl push it in and pull out cyl if no key you have to drill out the tumblers.
Wiki User
∙ 2015-07-15 19:57:45disconnect battery. remove steering wheel. remove turn signal switch. remove the buzzer switch with nedle nose pliers. then place key in ignition and set to lock position. remove lock cylinder retaining screw. then pull cylinder straight out.disconnect passkey connector from bulkhead and remove retaining clip.use a wire to aid in installation of pulling harness through column.
ignition module is found behind battery box right hand side
The 1994 Ford Aerostar ignition control module is located on the firewall in the engine compartment. The ignition control module will be on the drivers side of the firewall.
If the truck has distributerless ignition,disconnect battery for a few minutes,reconnect battery & drive the truck.The computer should reset timing within 10 miles.
1. Disconnect the negative battery cable. 2. Remove steering column covers 3. Disconnect the electrical connector from the ignition switch 4. Remove the screw retaining the switch to the steering column 5. The following installation is reverse of removal
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
In 1994 the 2.3 L 4 cylinder and the 4.0 L V6 engines are DIS ( distributorless ignition system ) The 3.0 L V6 was from 1995 on
screwdriver or punch
4 - modern combustion engines use 1 spark plug per cylinder. ANSWER The 1994 Ford Ranger 2.3 L has Ford's twin plug ignition system , so there are 8 spark plugs The 94-95 Ranger 2.3 has twin plug system, 2 per cylinder =8
rip it out or call a locksmith it happened with my 94 tbird
The 4 cylinder engine is 2.3 liters ( 140 cubic inches ) in a 1994 Ford Ranger
Should be correct
if it has a distributor you can.
remove the shroud covering the steering coloum and turn the key to the on position push in release pin over ignition and pull cylinder out.
This makes no sense. What is your question?