answersLogoWhite

0

Its difficult to do, be sure to disconnect the battery first................ 1. Drain fluid from primary. 2. Remove primary cover. 3. Unscrew Jack Shaft through bolt on starter from primary side. 4. Remove rear inner plastic fender cover just in front of rear tire and between bike frame. 5. Remove supporting bolts for oil bucket. 6. Remove oil bucket and disconnect oil lines at same time. 7. Unbolt the 2 bolts holding the starter in place. 8. Disconnect the electrical plug and positive lead wire at starter. 9. Curse the Harley-Davidson manufacturers for not making it easier to remove starter over the last 50 years. Install in reverse.

User Avatar

Wiki User

17y ago

What else can I help you with?

Continue Learning about Art & Architecture

Anyone have a 2004 XL custom sportster with a starter that slips with a grinding noise?

I have a 2006 XL1200R that intermittently does the same thing (I'm wondering if it has something to do with primary chain tension).


2006 Infinity G35 will not start Keep getting a clicking sound when trying to start Tapped starter but nothing HELP?

Ive got the same problem on the same year


What is the cause of hard shifting on a 2006 Harley Davidson XL 883 Sportster?

Hard shifting is caused by improper clutch cable adjustment or worn clutch plates. To adjust the clutch cable, loosen the locking nut at the hand grip and turn the adjustment screw outward, away from the end of the handle grip. Tighten the locknut, take the bike for a spin. It will either shift easier or the clutch will slip,(higher revving of the engine without going any faster0. If the clutch slips, back the adjusting screw to a closer position to the end of the handlegrip. If it is hard shifting again, probably the clutch is worn and needs replacing.


How do you replace the engine air filter in a 2006 sts cadillac?

Open hood. Remove plastic housing securing air filter. Install new filter. Replace what you have removed. Your finished!


How do you remove the climate control panel from a 2006 f150?

To remove the climate control panel from a 2006 Ford F-150, first, ensure the vehicle is off and disconnect the negative battery cable for safety. Use a trim removal tool or a flathead screwdriver to carefully pry off the panel bezel surrounding the climate control unit. Once the bezel is removed, unscrew the mounting screws securing the climate control panel, then gently pull it out and disconnect the wiring harnesses attached to the back. Reinstall in reverse order after any necessary repairs or replacements.