answersLogoWhite

0

It is bolted to the case on the trans.It slides over the shifting shaft and is held with 2 bolts. Be sure to align the marks up when adjusting before tightening down. I believe this is done when the trans is in the neutral position. The marks are molded in the plastic - one on the switch body and the other on the moving collar. They are little raised lines. Dan the tranny man

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you reset a fuel pump switch on a 1993 Ford Tempo?

how do you reset a fuel pump switch on a 1993 ford tempo


How do you replace the ignition switch in a 1993 Ford Tempo?

To replace the ignition switch in a 1993 Ford Tempo, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing the screws, then locate and disconnect the electrical connector from the ignition switch. Unscrew the ignition switch from its mounting position, replace it with the new switch, and reassemble the steering column cover before reconnecting the battery. Finally, test the new ignition switch to ensure it functions properly.


Where is the neutral safety switch on a 1993 Nissan Sentra?

The 1993 Nissan neutral safety switch can be found on the left-hand side of the transmission. The neutral safety switch will be near the front of the transmission.


Where is the neutral safety switch on a 1993 suzuki sidekick automatic?

The 1993 Suzuki neutral safety switch is located on the top of the transmission. You can access the switch through the shifting console.


Replace ignition switch for 1993 Buick century?

Replace ignition switch for 1993 buick century?


Where is the neutral safety switch on a 1993 Chevy cavalier?

The neutral safety switch, on your 1993 Chevy Cavalier, is located beneath the shifting column. The switch can be accessed by removing the shifting boot.


Where is the neutral safety or reverse light switch on a 1993 Mercury Tracer and how do you replace it?

Follow the positive cable wire from the battery and it will end up plugged right into the safety switch.


How Do You Replace A Headlight Switch In A 1993 Oldsmobile Cutlass Ciera?

how do you replace the headlight switch on a 1993 cutlas ceria*


What does the neutral safety switch look like and were is it located on a 1993 Buick lesabra?

what dose the neutral safety switch look like and were is it located on a 1993 buick lesabra at


How do you bypass neutral safety switch on 1993 Isuzu Rodeo?

Bypassing the neutral safety switch on a 1993 Isuzu Rodeo can be done by locating the switch, which is typically found on the transmission. You can disconnect the switch and use a jumper wire to connect the terminals, effectively bypassing it. However, this is not recommended as it poses safety risks, allowing the vehicle to start in gear. It's advisable to repair or replace the switch instead of bypassing it.


Where is the neutral switch on a 1993 Chevy Silverado?

there is a switch on the lever on the trans on the driver side


Neutral safety switch on a 1993 cougar xr7?

its on the transmission