0
Well...the first step is to remove the old fender. To start, you will need to remove the hood. There shouldn't be many hood bolts, but it would be advised to have some help holding the hood. Once you have this done, start removing the fender bolts. Be sure to remove any bolts or screws in the fender wells and ground affects (if on the body). Once you have all this done, pull the fender loose (don't force it off, theres always that one bolt you missed) and once its free, just reverse the process to get the new fender on.
What else can I help you with?
How do you replace the rear drive-shaft on a 96 tacoma reg cab?
Remove 2 small u-bolts from rear end yoke Pry drive shaft out of yoke Slide front end of drive shaft off front splines
What size socket do you use to replace o2 sensor on 96 quest?
22mm
How do you fix a fast blinking signal light on a 96 GMC Suburban?
Turn on that fast blinking signal light and check to see if the front and rear signal lights are both working, chances are you have a burned out bulb. If both front and rear bulbs are flashing fast, replace the flasher relay.
Where is neutral safety switch for 96 Dodge Intrepid?
Inside the transmission, on top of the valve body. Dodge calls it a trs ( trans range sensor)
Location of water temp sensor 96 Nissan pickup?
Front top of the intake manifold.
Where is the battery on a 96 dodge stratus?
Inside the fender in front of the driver side front tire.
Were is the computer on a 96 Sunfire?
passenger fender right behind the front bumper cover
How do you replace a Ingnition control module on a 1996 Pontiac trans am?
I think there is no 96 Trans Am. The Trans Sport module is on the rear center of the engine. Remove and replace it with standard US or metric tools. There are three electrical plugs to remove from socket. The Trans am didnt die till 2002 there was one in 96.
Can i replace the 4L60 trans in my 96 camaro Z28 with a 4L60e trans out of a 98 Z28?
The Camaro started using the 4L60-E in 1994, so that's what your 96 Camaro should be set up for already.
Where is battery located on 96 dodge stratus 2.4 engine?
In front of the driver side front tire. You have to remove the inner fender liner to access.
Where is the location of the vehicle speed sensor on a 96 chrysler town and country?
Front driver side of the trans, two wire connector.Front driver side of the trans, two wire connector.
How do you replace front pads on 96 subaru legacy?
remove old pads and replace then with new ones
Where is the horn located on a '99 Chevy cavalier?
On the passenger, inside the fender well on my '96. There are a few screws/clips to remove which hold the plastic fender well on. The horn is located in front of the tire.
Where is the battery located on 96 Chrysler Sebring JXI?
In front of the drivers side front wheel. The left front wheel and the front portion of the plastic inner fender needs to be removed to gain access to the battery.
Where is air ride compressor on 96 town car?
On my 1994 Town Car the pump is below the air filter in front of the left front fender. There is sort of a well compartment down there.
Will a 96 prelude trans fit in a 93 accord?
Yes, I actually bought a 93 accord trans for my 96 prelude. The 91-93 accords have the same engine and trans as the 92-96 preludes.
How do you replace a battery on a 96 dodge stratus?
remove left front tire, remove inner fender liner,Take the left (drivers side) tire off and access the battery inside the wheel well under neath the wheel well liner.
