take it to the dealer and wait for the bill $$$$$$$$$$.
When changing anything on a car, a person needs a diagram. A person can get an ignition switch diagram for this car, by buying the cars maintenance manual.
If you're not familiar with brake jobs in general, purchase a Chilton's repair manual that covers your vehicle. Good brakes are a number one priority.
You can't do it by yourself. You basically have two choices. First one is to visit local Mitsubishi dealer... It will cost you around $200. Second you can visit local company which specializes in electronic locks. They usually have required equipment.
let the engine running, lift off the ignition coil one by one after opening the screw...a tick sounds will be heard ... no tick sound and gasoline leak on the plug thread means the ignition coil is busted.
Your best source is a Toyota dealership. A possible alternative 'might' be an auto recycling yard but removing an ignition harness on a modern car intact could be difficult.
how to replace an ignition switch for 2005 chevy equinox
To replace the ignition switch on a 2005 Chrysler Pacifica, start by disconnecting the negative battery cable to ensure safety. Remove the steering column cover by unscrewing the necessary screws, then locate the ignition switch. Disconnect the wiring harness and unscrew the ignition switch from its mounting. Install the new switch in reverse order, ensuring all connections are secure before reconnecting the battery.
I have a 2002 Envoy and I have the same problem. I have to insert a pen or pencil in the hole right up under the ignition switch and push a wire to get my keys out. It gets old but what caused this I have no idea. I think it is something in the shift linkage.
Your switch on your steering column
We have full instructions at our enthusiasts forum www.trailvoy.com
We have some detailed instructions on our forum for this procedure. www.trailvoy.com
Your ignition switch has failed. There is a good chance that the wiring plug for the switch has melted slightly due to a blower motor that is pulling too many amps. You will have to replace the switch, plug, and blower motor.
It is in the fuel tank in the 05 model year.
where is the map sensor located on a 2005 gmc envoy
To remove the ignition switch from a 2005 Ford F-150, first disconnect the negative battery cable to prevent electrical shorts. Next, remove the steering column covers by unscrewing the screws securing them. After that, locate the ignition switch, which is mounted on the steering column, and disconnect its wiring harness. Finally, remove the screws or bolts holding the ignition switch in place and gently pull it out.
When changing anything on a car, a person needs a diagram. A person can get an ignition switch diagram for this car, by buying the cars maintenance manual.
fix for p0123 gmc envoy