if its computer orientated i would disconect the battery for 20 minutes
Drivers side you neec to remove the battery, meaning reset radio/clock etc after. Passenger side should be accessible. Cheers, J.
turn your key on leave 4 30 min should reset then change your crt fuse i just had da same proplem
No, but you can reset by disconnecting the battery for a little while to reset its memory and leaned values. Or it will relearn itself while you drive it.
Oldsmobile vehicles do not have inertia/reset switches.
You do not have to reset the computer after this repair. If the Check Engine Light is on it is not because you made this repair. If you disconnected the battery the computer will reset itself.
To reset the driving distance to empty on a 2012 Subaru Legacy, first ensure the vehicle is in the "On" or "Run" position without starting the engine. Then, press and hold the trip meter reset button on the dashboard until the display resets. This action typically recalibrates the fuel gauge, including the distance to empty reading. If needed, you can also try refueling the vehicle to help the system update.
Reset a fuel gauge? There is not reset for a fuel gauge.
press reset for tripmeter for a few seconds
There is no reset for the fuel gauge. The sending unit in the fuel tank has probably failed.
The oil gauge does not have a reset. Is malfunctioning, the sending unit has probably failed.
It will automatically reset when fuel is added to the tank.
Simultaneously press the "E/M" and "MODE" buttons and hold for three seconds. This will reset the MPG average gauge.
Happens to every one of these cars...question answered here http://wiki.answers.com/Q/What_is_the_easiest_way_to_reset_the_needles_on_the_fuel_and_temperature_gauges_on_a_1997_Buick_Park_Avenue
There is no reset button for the fuel gauge. Something is either wrong with the gauge or the sending unit in the tank.
To reset the fuel gauge on a 2005 Audi A4, first, ensure the ignition is turned off. Then, press and hold the trip odometer reset button while turning the ignition to the "ON" position without starting the engine. Continue holding the button until the gauge resets. After releasing the button, turn off the ignition and start the engine to check if the fuel gauge has reset properly.
Hold reset button for about 5 seconds then it should reset.
When the UTM (Universal Testing Machine) is switched off, the dial gauge reading resets back due to the mechanical design of the gauge. Most dial gauges operate with a spring mechanism that returns the pointer to a zero position when the machine is powered down. This is done to ensure accurate measurements upon reactivation and to prevent damage to the gauge during power fluctuations. Such resetting helps maintain the integrity and reliability of subsequent tests.