turn the key on pump gas 3 times to floor ,then turn key off . Now start engine.
Have you checked your maintenance manual? The instructions are in there; I've done it myself and I put the key in, turned it to the second setting and then pressed the button to go to the oil life and held the button down for 10 seconds - or something similar to that. (Just check the owner's manual to be sure).
this is for 2007 vw bettle but the concept is similarhttp://www.rootsrain.com/?m=200706
The difference is mainly in control bars. MS 2007 has so called ribbon toolbar. Also 2007 can save documents in .docx format. That is more standardized type of ordinary .doc document.
2007
Read the Manual
how do you operate a 2007 Lincoln Navigator message center
You take it to the car dealer and they will tell you how.
once the tank is filled the message goes out if not u might have a faulty level sensor or a elect fault theres no reset
To reset the oil change lamp on a 2007 Town and Country, locate the reset button on the instrument panel. Hold the button down for 5 seconds.
o I want to reset the oil light on my 2007 mustang 6cyl.
go to your oil percentage then hit and hold reset button
push in the info button on the dash a series of times until fuel life comes up and it will say reset fuel life then hold the button until it says reset it will then display fuel life 100 persent
On mine, you press SETUP twice and then press and hold RESET
well
By resting it on the computer manually
If your truck has the DIC (Driver information Center) Make sure the truck is in PARK. Change to the display "Oil Life Remaining" Press and hold the SET/RESET button on the DIC for 5 seconds. If you don't have the DIC the make sure the truck is in PARK and press the trip odometer reset stem for MORE THAN 5 SECONDS. The oil life will change to 100%.