It stays on until reset even if proper repairs completed. Some will reset if you disconnect batt for a while. if yours doesn't, any shop with a code reader can plug into your dash and reset for you.
I asked the question, got some info. behind the glove box, unplug the alarm from the control?
No, but you can reset by disconnecting the battery for a little while to reset its memory and leaned values. Or it will relearn itself while you drive it.
Oldsmobile vehicles do not have inertia/reset switches.
You do not have to reset the computer after this repair. If the Check Engine Light is on it is not because you made this repair. If you disconnected the battery the computer will reset itself.
How do i reset my service light on my 2004 Nissan
[l[
A demonstration of resetting the Nissan Altima Window is available in the links.
http://i44.photobucket.com/albums/f11/scotmech/Servicelamp.jpg
The best way to reset the engine warning light on a Nissan Primera p12 would be to take it to a mechanic. It is best to have a mechanic check it out to make sure nothing is wrong that could malfunction and put someone in danger. The mechanic will be able to reset the engine warning light.
I changed my rediator and the engine light came on and remained on, how do i get this light off
To reset the driver window regulator on a 2008 Lincoln Navigator, first ensure the vehicle is on and the window is fully closed. Then, press and hold the window switch in the "up" position for about 5 seconds after the window reaches the top. Next, open the window fully by holding the switch in the "down" position, and again hold it down for about 5 seconds once the window is completely open. This should recalibrate the window regulator.
No, there is not a reset button on the Nissan Xterra. However, there is a reset button on the clock in the Nissan Xterra to change the time. To reset the car, a technician would have to use their computer.
How do you reset nissan 2002 frontier transmission?
How do you reset the security system 1995 Nissan Sentra?
To reset the stopping position of the rear window wiper on a 2006 Nissan Murano, first turn the ignition to the "ON" position without starting the engine. Then, turn the rear wiper switch to the "ON" position and wait for the wiper to complete its sweep. Once it reaches the desired position, turn the wiper switch off, and then turn the ignition off. This should reset the stopping position of the rear wiper.
How do you reset the security system on a 2003 nissan xterra?