I asked the question, got some info. behind the glove box, unplug the alarm from the control?
the starter is located right below the factory air filter box
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
The solenoid/starter motor assembly is installed on the lower part of the engine next to the transmission bellhousing
Most commonly, it's the starter or the starter was wired wrong when it was installed. More rarely, it can also be the keyswitch or even a bad gear on the flex-plate.
The solenoid/starter motor assembly is installed on the lower part of the engine next to the transmission bellhousing
Remote start was not available on a 1999 Jeep.
Because the flash drive memory they installed on the remote is full
Not sure, but had to run a wire from the battery to starter and hold it on a starter terminal to turn the starter after replacing it. I think it may be an ignition switch problem but haven't figured out how to get to it yet.
The new Chevy Volt has a remote starter, as do the newest models of Subaru, Lexus, and Acura cars. It is also possible to have a remote starter installed into the car of your choice, even if it does not come with the factory option.
if you push the button and it starts then it is installed
Assuming it started before the starter was replaced, the starter and/or starter wiring are not installed correctly.
no installig a starter wrong will not cause engine knocking. all that will do is maybe short fuses, heat up wires, ruin your starter, or melt wires. knocking isn't electrical it is mechanical like lifters, pistons, valves, things like that
Electrical energy to mechanical energy.
the starter is located right below the factory air filter box
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
YOUR + LINE IS GROUNDING OUT WITH YOUR - LINE U NEED TO CHECK YOUR RADIO LINES... BATTERY CABLE... EVERYTHING BEHIND THE DASH AND IN FRONT OF THE DASH,,, WIRING IS YOUR ISSUE.
Only if one was installed.