I have a 2002 Accent. May work on other models. The tools you will need: A #2 Phillips head screwdriver. A Standard head screwdriver. First take out all of the screws in the door panel. There is one in the handle that opens the door, and 2 in the door panel handle. Use the flat screwdriver to pop off the covers. Taking out the door handle is a little tricky. Slide it towards the front of the car and pull out. You might not get it the first try. Once you get the handle out enough, you will be able to see 2 metal rods connecting to it(towards the back of the car). Using the standard screwdriver, pull the plastic piece(either blue or red) towards you and it should unclip from the rod. Next, pick up on the rods and they should come out of the handle. Once all screws and the door handle are removed, you can take off the panel. To remove the door panel, simply pull it off, starting at the bottom of the door and prying your fingers between the panel and the door. You will hear a series of pops. You didn't break anything. If it doesn't come fairly easy, don't pull too hard. You may have missed a screw. Once the panel swings freely on the window slot, get it close to the door and pick up, as the top rests in the window slot. If you have power windows, you will have to unclip the wires going to the switch.
A flush door has panels that are mostly flat and take up the entire space of the door. A panel door has loose fitting panels that fit into grooves that make up the frame of the door.
It isn't easy. It bolts on from the inside of the door. TAke the door panel off.
To install an exterior door handle on a Cherokee Jeep, first remove the window crank handle and the three screws in the inner door trim panel. Second, remove the inner door panel from the door using a trim stick and take off the vapor barrier inside the door. Third, remove the nut on the rear of the door handle, position the exterior door handle, and secure in place.
Roll the window down. Carefully wedge a nonmetal object in between the glass and the door panel. Try to pull the trim panel up over the top of the door edge. Sight down to the door latch with a flash light. It helps to do this in the dark of night or indoors. Then take a long rod of some sort and trip the release mechanism. After you get the door open. Remove the trim panel and correct the problem. Don't try to slip the trim panel over the top before removing it. This is when the panel could be damaged.
You will need to remove the inside door panel of your 2002 VW Jetta. Remove the wiring harness from the mirror. Remove the side view mirror retaining bolts. Reverse the process to install the new side view mirror.
Take it to a dealer
remove the dash board panel around it and take it out
take it out
I had my 95 Accent handle break. I had to take the inner door panel off. There is a 'c' clip on the inside of the lock for the door. Remove it. There are 2 nuts holding the handle in place. It is very awkward to do. Just don't lose the 'c' clip. It is small.
firs look for all screws of the door if they are show it, them some times there's more screws hid inside of the plastics so check for edges on the door panel after that take a screw driver and push in to the edge of the door panel and the metal of the door.
hammer PS use the right to
how many amounf of frion (R 134) do i need to charge for hyundai accent 2006
Take out the back seat
Take off all the screws on the door panel.
take it to the dealership doche bag
Dot 3
5