17
Locate the starter at the rear of the engine on the passenger's side. Unplug the wiring. Remove the bolts that hold the starter. Remove the starter.
It is attached to the starter, which is under the car. Look for the rear of the starter sticking out on the driver's side of the car. Remove the housing cover (3 bolts), and then the 2 bolts hold in the starter to remove it and gain access to the solenoid. TD
Disconnect the - battery cable Raise and support vehicle Disconnect wiring harness at starter Remove starter mounting bolts Remove starter
Drop the dust cover. Drop the drive line take bolts out and there ya have it! It is difficult to remove the starter on a Blazer. Disconnect battery (negative), disconnect 2 wires on starter, remove 2 bolts - it drops down but you must still remove a cross member to remove it from the car
Begin by removing the positive cable from your battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new Ford starter.
Remove the wires from the starter. Remove the retaining bolts. The starter will easily come out. Reverse the process to install the new starter.
how do i remove old starter from 1996 Pontiac transport
Remove the positive cable from your 2004 Pontiac Vibe battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Begin by training the water from your 1997 Pontiac Bonneville cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
Begin by removing the wiring harness from the back of your 1997 Pontiac Bonneville headlight. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight.
Begin by removing the positive cable from your battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new Pontiac Montana battery.
The thermostat is on the top of the motor where the top radiator hose attaches to it. The housing for it should be held on with two bolts. Remove the bolts and lift up the cover. There's the thermostat.
You can feel around for the bolts and wires once you remove them you have to twist and flip the starter to remove it it sucks a hoist will help and lots of light ... small hands/fingers too
1.Disconnect negative battery cable. 2. Climb underneath and locate the starter. 3. Disconnect cables and wires on starter. 4. Remove bolts holding starter in place. 5. Remove starter. Installaton is REVERSE of removal
remove the headlight housing, its only the two bolts on top of the housing, and the turn signal is the white connector, twist it closkwise and pull it straight out, the bulb is a 3157
jack up vehicle and support it with stands.the starter is on the front of the engine,there are two bolts that hold the starter up.you will need a 15mm socket to remove the bolts. you will also need a 13mm socket to remove the power wire off the back of the starter.then there is one more wire you will need to remove and its an 8mm.just do the reverse to install it
1. Disconnect battery. 2. Jack up vehicle and support w/ jack stands 3. Disconnect positive bbattey cable from starter 4. Disconnect wire from solenoid 5. Remove (2) 15 mm bolts from bottom of starter and remove...