It depends on the age of the vehicle as newer cars use a coil for each spark plug, resulting in more expensive labor. It also depends on engines, if it is a V6 or above, the positioning of the engine could be so that three cylinders are positioned towards the rear of the engine compartment (the firewall) in which case you'll be paying more for labor really than parts (it's hard to work back there)
It can cost anywhere from $100 - $500+
$155.00
$109.99 item#IG23401 at schucks.com
about how much does it cost to repair a car ignition tumbler
If you're positive that it's teh ignition switch, the part is as low as $23 shipped - if you have a mechanic install it - he'll trouble shoot to make sure thats the part you need (being the problem), could cost you oup near $200 installed.
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
How do you replace the ignition distributor on a 93 mx6 v6 pics?
To replace an ignition switch on a Windstar, it will cost you approximately $200. This can also depend on the age of the vehicle as well.
$109.99 item#IG23401 at schucks.com
It costs $4,500 to $5,000 to replace ignition coils on a land rover 09 LR two
Well I had an ignition coil replaced in a 1990 Oldsmobile and the coil cost approximately $50. Labor would probably cost approximatley $35.
It costs about $240 to replace ignition coils on a land rover 09 LR.
about how much does it cost to repair a car ignition tumbler
At least $75
My 1983 300D cost over $700. The ignition is encased in hardened steel to prevent theft (and repair)
I just got quoted $1,200 for 6 coils & plugs on the 2005 Escape. Ugh.
take your key to a hardware store and ask them to copy it. it wont cost much. if you lost the key completely, you are skrewed
how much it cost to replace my sun root
It cost me 268.00 dollars today. The work was done by a local locksmith. My key would only go halfway into the barrel or switch.