I don't think that this is supposed to be a maintenance item. I would guess you change them when they start leaking. On my friend's 2003 G35 sport coupe we were about to replace the spark plugs and we found a leaking spark plug tube seal:
http://www.YouTube.com/watch?v=G1G1LpksqPM
If you have any reason to remove the valve cover, and replace the gasket, you might as well go ahead and replace the seals. The gasket set should include new seals, as well as special washers for the cover retaining screws. (About $30.00 for a set.) There are little tabs on the thin sheet steel plate, inside the valve cover. You have to bend the tabs out of the way, before knocking out the old seals. A screwdriver and mallet should do the trick, but take care not to scratch the bore (the sides of the hole in which the seal fits). It will be nice if you can press the new seals in, instead of knocking them in. Bend the little tabs back, and you are ready to go.
Remove the spark plug wire from your 2001 Mercury Grand Marquis. Remove the spark plug with a 5/8 deep well socket, white turning it to the left. Reverse the process to put in the new spark plug.
Changing spark plugs is relatively easy. Disconnect the batter and spark plug cables, and remove the old spark plugs. Next replace the spark plugs with new ones, reconnect the spark plug cables and battery.
The spark plug gap is 09.96 The spark plug gap is 09.96
The rubber end on the spark plug wire.
you take the spark plug wire off and get you a 13/16 wrench and the plug will be right underneath the gas tank,you can get to it better on the left side of the bike.The side were the clutch lever is.Just unscrew and put the new one in.
To change the spark plug seals on a Nissan Pulsar N15, first, ensure the engine is cool and disconnect the negative battery terminal. Remove the ignition coil or spark plug wires, then unscrew the spark plugs using a spark plug socket. With the plugs out, carefully remove the old seals from the valve cover and replace them with new ones. Reinstall the spark plugs, reconnect the ignition components, and finally, reconnect the battery terminal.
valve stem seals
Spark plug tube seals need changing
when do you have to change a spark plug and how many miles when do you have to change a spark plug and how many miles
They seal oil/water/dirt out of the plug tube.
If it is a 3.2 V6, it's the spark plug tube seals.
100k miles or 80 if your conservative..
2.5 engine you can only buy a new valve cover from dealer
Jaguars have plug seals.
replace valve cover gaskets & spark plug tube seals
The seal on the top of the plug tubes are leaking. You need to change the valve cover gasket and plug tube seals.
To change the spark plugs in a Chevy Celebrity: 1. Give the spark plug boot a twist to free it up from the spark plug, then pull on the boot to remove the spark plug wire from the spark plug. 2. Use a 5/8" spark plug socket with an extension and ratchet or breaker bar to loosen then remove the spark plug. 3. Set the gap on the new plug to .045" then screw it back into the spark plug hole in the head. Tighten the spark plug and replace the spark plug wire. I change the spark plugs one at a time to keep from getting the spark plug wires on the wrong spark plug.