get a high performance chip for the computer.
yes the s10s were the same from 94 to 04 exept for the interior and grill change in 1997-1998
There is no speed governer, the car's powertrain control module is responsible for not only governing the speed, but making the car work.
What I believe your trying to ask is how to remove the drive shaft? If so than all you need is to remove the
The fan clutch on a 1997 S10 has a bolt on the center of the front. Remove the bolt while holding the clutch still. There is a special tool to grab the clutch fan from the rear to hold it while removing the bolt.
Yes, Sonny Perdue is a Republican, but he was a Democrat until 1998.
It has no governor. Speed is controlled by the computer.
You'll have to remove the driveshaft first.
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.
You can't take off the "governor" on any computerized car.
you need to get a power programer
To remove the door of a 1998 S10, start by disconnecting the battery to prevent any electrical issues. Next, remove the door panel by taking off screws and clips, then disconnect any wiring harnesses. Support the door with a jack or have a helper hold it, then remove the hinges by unscrewing the bolts. Finally, lift the door off the hinges and set it aside.
It has no governor. Speed is controlled by the ECU.
check your answer
will 2002 monte carlo rims fit 2000 s10
Drain the water from your 1998 Chevrolet S 10 cooling system. Remove the water pump return hose. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
The 1998 and newer S10 with the 2.2L engine does not have a serviceable pcv valve.