Before we begin, a note: At 3.6 volts and 350 milliamps per LED, this leads to just over one and a quarter watts, not the one watt you specified.
Now, for a 12 volt adapter, each LED would only receive one third of its rated voltage if you wired each LED in series. If you wired them in parallel, you would draw a lot of power, but end up burning out the LEDs with almost 4 times its rated voltage.
You would need to wire 3 of the adapters in series, have the 36 volt output wired to the LEDs in series, dividing by ten, giving you 3.6 volts per LED.
Experience
== ==
lots
How to splice s video to RCA
There are three nickname choices that scientists are still trying to figure out. These suggestions are, Juicy Dumpling, Spicy Turnip, or Crispy Banana. Please, tell the scientists what your decision is by calling them at 860-484-9281. Thank you.
I don't know. Mine is burnt and trying find a replacement but not able to find it. If anyone knows then please let me know
Yes. It is simply a threaded male adapter. But what are you trying to accomplish? what you are trying to do may not comply with code and may create a health hazard.
I would recommend looking at electronics websites or even trying sites like eBay or amazon. Just be wary, because cheap doesn't always mean good, and that could end up costing more in the long run.
I was only trying to please you.
I really odn't know what strategy itwas im trying to figure it out please help im in a half day crisis! Was it knowledge? I don't know! Tell me!
Adapter for what, exactly? You could be trying to install a different buttstock type, Picatinny rails, or a number of other accessories. Other than some sort of unspecified adapter, you really don't tell us what it is you're trying to do.
It depend on what the load of the device that plugs into it is. The mA rating is the maximum amount of amperage that the adapter can produce. The 500 mA adapter will produce about a half amp whereas the 1200 mA adapter outputs 1.2 amps. So one is about three times larger that the other. Check the device that you are trying to power for a mA load and that will tell you whether you can use it on the 500 mA adapter.
Im having the exact same problem with my Tony Hawks American Wasteland game somebody please help.
This mainly depends on what type of USB adapter you are trying to troubleshoot, and what it is you are trying to connect it to. If it is a WWireles USB adapter going into a computer, then it will allow you to connect to WiFi. To use this you just plug the USB cable into the USB port. Then you might see a window on the computer screen saying New Drivers Found and it will ask you to install these New Drivers. Click Install and then you will have access to WiFi on that computer.
Get a life stop trying to be on electronics all thetime go out and get a girl or man
What it means is it cannot find wireless adapter, make sure that you have turn it on.
Try turning off the autoreverse function.