Is it a new starter motor? It may be incorrect.
hello i need to know what wires i need to hook up for my aftermart remote start in in 94 Chevy s-10 truck with a 2.2 motor
Wires connected to the starter incorrectly or defective ignition switch.
Too broad of a question to answer without knowing the make of your truck, and the motor which is in it.
you shorted something. is there a wire grounding out somewhere?
Check motor mounts
I have seen some that would go in backwards But 99% of them will not set flat on the fly-wheel if it is backwards. The clutch disk will hit the fly-wheel bolts if not installed right.
it isn't but My Lego 8258 Crane Truck is motorised with remote control using 1 IR receiver, 1 XL motor and 1 M motor. The XL motor is placed in where the V8 engine is to move the crane truck forward and backwards. The M motor is placed between the battery pack and the cab to control the steering
Spark plug wires are not installed correctly or the engine is out of time.
2004 mercedes truck wont start sometimes. Why
The truck is heavier
You would reverse rotation on a 3 phase motor to get it to run backwards. Say I fill up a tank truck from a lake. I turn on my generator. I run the motor in one direction. Then I drive the tank truck and the motor to a different location. Then I turn on my generator. I attach the hose to the motor on tank truck. I throw the switch to make the motor run backwards. I aim the hose at the fire in your house. Aren't you glad that I can make my 3 phase motor run backwards?
What was the first year seatbelts were installed in a chevy truck?
In line filters are directional. check that filter was not installed backwards look for arrow on the side of filter. arrow should point towards engine an away from fuel tank
You gotta start by figuring out what's wrong with it. You need to determine if it's the blower motor itself, or the power supply, then troubleshoot to determine the exact cause.
1500 chervrolet truck need a motor
Hard to say. How do you know it was installed backward? It could be the converter will work in either direction. If you look at converter and it has inlet and outlet stamped on the converter then it can only be installed in one direction and it very well may have been damaged. Considering the mechanic make the mistake I would demand a new converter be installed and not the one that he installed backwards.
You may have a vacuum leak