answersLogoWhite

0


Best Answer

You may have a vacuum leak

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause a 93 Chevy truck heater and air vents to shut off after about 10 minutes The blower motor is still running strong and new blower motor and resistor installed?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the blower resistor on a 2000 Mercury Cougar?

On the passenger side of the vehicle, under the dash is the blower moter, there are two wires running from it, the one running to the resistor is mounted on the firewall. you remove the two screws with a star shaped screw driver, unplug the old resistor and plug in the new one...takes about 15 minutes.


What happens when the blower motor resistor goes bad?

What can happen when a blower motor resistor goes bad is that the motor will run and then suddenly stop running on a regular basis. Sometimes the blower fan will not turn on and cause the motor to overheat.


How do you know if the blower motor resistor is bad?

A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.


Where is the blower motor resistor on a 1998 f-150?

The blower motor resistor is located under the front dash on the passenger side of the truck. It is a fairly simple job to replace...maybe 15 minutes. The blower motor resistor is located under the front dash on the passenger side of the truck. It is a fairly simple job to replace...maybe 15 minutes.


Why is the fan blower not running in switch positions 1 2 and 3 on your Mazda 626?

Defective Blower Motor Resistor Pack. Replace it.


Where is the blower resistor on a 92 Honda accord lx?

The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.


Why does the blower only work on high and no daytime running lights?

A blower motor that only works on high is normally caused by a defective Blower Motor Resistor Pack. DRL, do not have a clue.


What is the problem when the fan speed only works on high for a 2008 chrysler sebring?

The blower resistor has failed.The blower resistor has failed.


Where is the blower motor resistor located in the rear of volkswagon Sharon?

The blower motor fan cools the resistor so the resistor is usually located close to the blower.


Where is the heater blower motor resistor on a 2004 Malibu?

The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.


How do you replace blower resistor on a 2006 mustang?

# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal


Where is the blower motor resistor on a 1998 Chrysler Town and Country?

The resistor is under the hood on the passenger side. It is installed under the wiper cowl, over the passenger side strut tower.