# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal
where is the location for a blower motor relay on a 2006 ford freestar
Blows on #4 only? I would replace the resistor. #4 speed by-passes the resistor.
Resistor is located behind the blower motor assembly.
how to replace the alternator on 2006 mustang v6
Under the hood on the passengers side located in the a/c evaporator housing next to the blower motor and held in place by two screws...............
They generally locate the heater motor speed resistor nearby the blower motor because the resistor depends on the blower to keep it cooled.
The blower resistor controls the speeds of the blower motor Hi-resistance lower motor speed Lo-resistance higher motor speed
The heater resistor coil is located on the blower motor on the 2006 T300 Kenworth.
blower motor resistor needs to be replaced
blower motor resistor
it is under the glove compartment on the passenger side of the truck
Only your forth speed will work when your blower resistor is gone, this is how you can tell. Under the glove compartment you will find a plastic cover that's about a foot by 1/2 foot, just pull that off. Then you will be able to see the blower and a plug that has 4 wires comming out of it. Unplug it and take the 2 small hex blots out, then the resistor will slide out easily. Screw the new one in, plug back in, replace the cover and your good to go. Nick Parker.