0
Is it legal to machine automobile rotors when the are below OEM discard specifications?
Nope, they have minimum thickness specifications for a reason. That reason being safety. It would be pretty pointless to machine rotors that are too thin just to save a couple of bucks, if they fall apart at highway speed and you crash your car (or worse). If you know a machinist that would do it and is willing to accept responsibility for your death or someone else's, by all means, do the rest of us a favour and report him to the DOT.
What else can I help you with?
What does it mean to machine the brake rotors and drum brakes?
The rotors in disc brakes and the drums are what the pads and shoes rub against to stop a car. With use, the surface can get grooves in it or a build up of rust scale; reducing the braking efficiency. To machine the rotors and drums, they are put on a lathe that cuts a new smooth surface on the face of each. Depending on wear, any given rotor or drum can probably be turned 2 or 3 times before needing to be replaced.
Removing front brake rotors on 98 Mazda millenia?
Tap on your 1998 Mazda brake rotors with a hammer or mallet until they become loose. The brake rotors will simply slide off.
When changing the brake pads on a Mercedes ML320 can you skip the turning of the rotors if the rotor is smooth and hasn't gone metal to metal?
Yes, as long as it's not warped or anything. The rotors on my cars are also smooth & not warped and I've never turned the rotors in 140,000 miles. Some people turn the rotors as a matter of fact.
2001 S10 2 wheel drive front rotors have sensors?
The front wheels have abs sensors if applicable. The sensors would be mounted to the spindles not the rotors.
Can a car stop without rotors?
Yes, If you hit something. Rotors are very essential in stopping, that's what the brake pads are pressed in against to bring your car to a complete stop.
Can rotors be resurfaced on a 2003 dodge 1500 pickup?
Yes, but they come with such a low discard measurement, it is best to discard them instead of resurfacing them.
What is the minimum brake rotor thickness for a 2003 Ford Excursion?
Got these from ford last night for an 03 7.3L 2WD DISCARD at: Front rotors 1.417 Rear rotors 1.010
What does it mean to machine a part?
Normally it means to bring it back to factory specs. An example would be to machine brake rotors. They would pretty much cut the rotors with a machine to get them back to factory specs.
What do yo call the machine that turns rotors?
Brake Lathe.
How do you measure thickness of brake rotors?
The thickness of brake rotors are measured with a tool called a caliper. The specifications for the particular car will show the minimum thickness that a rotor can still be used.
Minimum thickness for rear brake rotors on a 2005 mustang?
The minimum wear or discard thickness is cast into either the front or backside of the rotor
How do you clean rust on automobile rotors?
You don't need to, The disc pads will remove it instantly as soon as brakes are applied.
Are brake rotors universal, or do they vary depending on the make and model of the vehicle?
Brake rotors are not universal; they vary depending on the make and model of the vehicle. Different vehicles have different specifications for brake rotors, so it is important to use the correct ones for your specific vehicle.
Can you repair Mercedes brake rotors?
depending on the material you can machine them true again
What are the brake rotor discard specs for a 1988 Oldsmobile cutlass supreme with 4 wheel dics brakes?
The minimum thickness specs are stamped into the rotors.
Chrysler front end shakes when you hit the brakes?
Your rotors are warped. You need new brake pads and the rotors turned at a machine shop or replaced.
How do you change the front rotors on a 1999 Honda Accord DX?
they have to pressed out from a machine shop.
