You can bend PVC pipes a little, in any direction, for a short time, in the long run, any glue joint or fitting will fail if left stressed by bending or sagging, so be sure to use the right clamps. PVC pipes can be bent more or in tighter curves if you screw it more or heat it up to melt it at any amount.
Possible air lock in the heating pipes. Common after changing thermostat. look for a bleed screw on the heating pipes between the engine and interior, or loosen one of the heater pipes., after engine has warmed up. Run engine to dislodge trapped air.
If the hot water tank is off it is possible. It is also possible for the cold water going to the hot water tank to freeze. Insulate all pipes that are exposed - or let them drip (this is more expensive!)
· Ukulele · Uilleann Pipes (bagpipes)
Copper
Yes, the Irish play bagpipes, as found in Scotland. There are many pipe bands in Ireland that use them. However, the Irish also have their own form of bagpipes called the Uilleann pipes. These use a bellows controlled by the arm, rather than blowing into them. They are more associated with traditional Irish music, and have a different sound to the bagpipes that are associated with Scotland.
Start by turning all the pipes in the same direction, to make long pipes. I Made all the pipes from the top go down, and the down pipes, i made them horizontal. ( just the straight pipes, not the turnings one) After that you have some kind of order. You just have to link the long pipes with the different sources, based on the pré order you've made. It should be ok :)
What ever pipes need to be hit. Especially hard to get to, out of the way pipes that have to be hit fast and hard so other pipes get the message.
no, it is not possible
Not if they are OEM tailpipes. If your changed them it is possible.
Internal engine antifreeze leak what else could cause besides headgasket? there is no antifreeze in the oil it is clean
You gotta connect the pipes together to make it to the other pipe but you gotta work fast
The same way you turn screws. Left. Remeber: "Rightie - Tighty / Lefty - Loosey" :D
Double submerged arc welded pipes has two types, one is spiral welded pipes, and the other is longitudinal welded pipes which are different from EFW pipes.
some people will use just plain plywood. soak it get it wet and it should bend and role fine
this question is vast. if no hot water is not coming out the pipes its possible the pipes can be blocked or the valves are blocked. if the temp is not hot, check wiring to the geyser or the element might need to be changed
Mostly lead pipes, but they avoided using metal where possible (it was expensive).
Yes, but, it isn't particularly easy. You should practice on flat stock first.