Providing that the vehicle does not have to pass an emissions test
If you know the value of the resistor you can cut the wires going to the lock cylinder and solder in a resistor of the correct value.
Remove it from the car OR It can be flushed by a knowledgeable person with the correct equipment.
enjoy your vacation,everything on your test paper looks correct,
Yes, you can do this, by why in the world would you want to? I agree it can be done, but you will need a resistor for the hot side of the coil. Contact one of the manufacturers of aftermarket ignitions such as Accel or Mallory and ask them for the part number of the correct resistor. It goes between the wire presently connected to the BAT terminal on the HEI and the + terminal on the new coil.
Actually both right and left lungs but everything else is correct.
Yes, resistor is correct.
Replace the torque converter.
The correct question is what is the voltage drop across a resistor or the current flowing through the resistor using Ohm's Law where Voltage = Current x Resistance
No, it is illegal to remove a catalytic converter punishable with a $1,000 fine. Besides the car will not run correct with the converter missing.
A well known application of a microelectronic system is the AC to DC converter. If, for example, you wanted to take electricity from a wall outlet you could use 4 diodes a resistor and a capacitor of correct values to change it into a DC current.
If you know the value of the resistor you can cut the wires going to the lock cylinder and solder in a resistor of the correct value.
This is programed in the prom in the computer. Check the throtle cable adjustment to see if it is correct.
If you know the value of the resistor you can cut the wires going to the lock cylinder and solder in a resistor of the correct value.
You should use the same size resistor; a 47 kilo-ohm.CommentThe correct spelling is 'kilohm'.
Replacing the 1997 Chevrolet suburban blower motor resistor can correct your air output issue. The air output issue could because by other things.
If you know the value of the resistor you can cut the wires going to the lock cylinder and solder in a resistor of the correct value.
If you know the value of the resistor you can cut the wires going to the lock cylinder and solder in a resistor of the correct value.