If you know the value of the resistor you can cut the wires going to the lock cylinder and solder in a resistor of the correct value.
I have a Lumina too and most commonly its 3 coil packs
The best place to find a schematic for the steering column is in a FACTORY SHOP MANUAL available from AUTOBOOKSONLINE.COM or MOTORLIT.COM.
Check your fuses
I have a 1999 Lumina LTZ and the the power steering reservoir was impossible to find. Much like the other components in this monster 3800 engine like the battery hidden under the washer fluid....the power steering reservoir is located underneath the alternator. Be careful that when you remove the cap you don't get debris from the top into the reservoir.
GO BUY A NEW IGNITION SWITCH AND KEY SET TO INSTALL IN THE COLUMN. It's not that simple smart#@$! If anyone can answer the question intelligently I would appreciate it.
I believe it happens when the steering wheel is turned either to the left or the right. My girlfriend didn't have my steering wheel lined up straight and broke the key in my ignition!
How to remove steering wheel on Chevy lumina 2000
Yes
I need a Diagram for a 1995 Chevy Lumina iginition switch??
You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.
On top of the power steering pump dummy
The button to turn on the hazards in Chevy lumina is on top of the steering wheel column.
pull steering wheel move everything out from around ignition switch and there is 2 hair thin wires they break very easy put them back together put heat shrink tubing on them and your good 2.oo fix
I have a Lumina too and most commonly its 3 coil packs
why
pull steering wheel move everything out from around ignition switch and there is 2 hair thin wires they break very easy put them back together put heat shrink tubing on them and your good 2.oo fix
Remove the belt from your 1992 Chevy Lumina power steering pump. Remove the power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.