If this is a 4-cyl, it is a very in-depth process to replace the seal...removing motor mounts and the majority of engine components to be able to pull the camshaft. If it is necessary, follow instructions for replacing the head gasket on your model. You can replace the seal at the point of removing the Timing Belt.
A camshaft seal keeps engine oil in and dirt/water out.
a lot of work. the transmission has to be removed.
The transmission would have to be removed, which is a really big job
Only by replacing the seal. Just dive in and do it, waiting will only make the problem worse.
Yes there are sealers out there that can be used to seal or repair the gasket
A camshaft seal keeps engine oil in and dirt/water out.
sounds like too much oil pressure, try replacing the PCV valve
how to change camshaft oil seal 95 pathfinder
You have to pull drive shaft and take off trans- the front pump seal is on the front of the trans behind the converter. It looks just like the one at the end of your tail shaft. Except for the labor, replacing seal itself is easy once you get to it. If you are mechanically inclined and have the tools, you can do it yourself.
Not sure what the question is. What, Where etc...
very carefully
Take off camshaft seal bolts
Rear camshaft seal bad. Replace. located behind cam sensor.
Whatever seal the fluid is coming out.
remove the seal and slide it to the side
youtube that sh*t bro haha
Replacing the seal is the only good, permanent way. The seal is old, cracked and leaking.