answersLogoWhite

0


Best Answer

If it has blown, you can cut it off and glue the flaps closed, buy a new one which can be expensive and dangerous to install if not done by a professional, or buy a non-airbag cover which can cost about 30 bucks and is easy to install yourself.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is there an easy way to get one of these airbags back into the steering wheel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Can't turn your Ford steering wheel and start ignition?

It's easy man...Don't worry too much. Just try to start engine and the same time wiggle your steering wheel.. it will cool you down. Cheers Karen.S


How do you remove a tilt steering wheel?

Hi ej here !. remove cover plate on the bottom of the dash then unplug the connectors go under the hood and remove the bolts that connect steering gear and the shifting rod then go back inside unit and take loose the bolts holding the tilt wheel make sure someone holds the wheel so it will not fall on you.


Where is the fuel pump in a 1999 Acura 3.0 CL?

Unscrew the panel under the steering wheel, and you should see it bolted underneath. Really easy to replace.


How do you install a signal switch blinker on a 1995 Chevy Corsica?

disconect battery & pull fuse that controls air bag & wait 15 minutes (this will disable the airbag There are two torx screws on the back of the steering wheel, turn your wheel to access them & remove. Pull off horn/airbag,easy does it. Disconect the wires on back & place in safe place Remove nut holding on wheel with 13/16 socket. Pull wheel off with steerig wheel pulller. Remove snap ring. Move Coil pack out of way. Remove small metal band that holds on the metal star looking thing. You will need to use a steering wheel lock plate removal tool. Now you have access to switch. remove a few torx bolts & it will be loose. Disconect the harness & pull through.


How do you remove and replace ignition actuator on a 95 mustang?

Contrary to the repair manual; you do not need to remove the steering wheel. Remove the bottom dash panel below the steering wheel and then the bottom black steering wheel cover (3 screws). You will see a 1/8 inch hole and pin below the lock set. Put the key lock in the neutral position and push the pin and remove the ignition lock set. Put the new lock set in the neutral position and insert it. Turn it to the off position which resets the lock pin.

Related questions

Is it easy to remove the steering wheel from a discovery ll?

yep, real easy. but do you want it to go back on again? Mmm, dont ask me.


What kind of simple machine is a steering wheel?

a wheel and axle easy


What is a good steering wheel cover that will ad grip but be easy to clean?

Wheelskins is one of the top brands available for easy to clean steering wheel covers.


How do you setup thrustmaster steering wheel on UK truck simulator?

just change it from keyboard to keyboard and steering wheel and then calibrate your wheel and pedals in settings easy.


How do you adjust the steering wheel on a1998 Toyota corolla?

Adjusting the steering wheel on a 1998 Toyota Corolla is easy. All you have to is find the latch at the bottom and push in to adjust the wheel.


How do you take a steering wheel off a opel corsa?

pull of thehorn cover then take of the nut and the steering wheel should pull off easy?


How do you drive a go kart?

peddle and use the steering wheel easy


How do you change a steering wheel on a Nissan primastar?

easy take it to the auto body


Where is the horn on the 1994 Buick Skylark?

Well the easy answer is "In the middle of the steering wheel.


Squeaky steering wheel?

A steering wheel might be squeaky because it might be the bushings that need to be replaced. Also the power steering fluid pump might be going bad. Both of these are easy fixes.


What does it mean when your steering wheel is easy to turn one way but is hard to turn the other way?

The steering gear has failed.


How do you make a billy cart steering wheel?

well I've got my steering wheel out of an old car that's much more easy its hooking it up that's hard