answersLogoWhite

0


Best Answer

There are two circuits at the multifunction switch lever. One is for the flash to pass. The other is the normal high/low beam circuit. The two most likely problems are a lack of power from the headlight switch, or a broken wire at the multifunction switch connector. The second is prone to happening if you tilt the wheel frequently.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Lights only work when you hold the brights lever back anyone know whats the problem or how to fix of a 1993 dodge Dakota?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture
Related questions

Headlights tail lights brake lights and horn wont work on my 1994 dodge Dakota can anyone help?

I am having the same problem. Did you get yours fixed? I can't seem to locate the problem area. Changed all of the fuses. Looking for the relay switch to change and then the last thing i can think to replace it the switch. Let me know if you fixed it. Thanks


Why did my 1993 Dakota suddenly lose the lights radio horn and ABS and brake light is the only lights on your dash All of the fuses relays and grounds are fine?

did anyone find the answer to this problem yet i just had this problem it in the plug behind the fuse box in the cab on the outside below the master cylinder theres a rubber boot that holds a lot of moisture that rots t he wires off my power wire rotted off on the inside there was green comming out of the plug


Why does your reverse lights stay on is it a sensor or other on your 2002 Montana has anyone ever had this problem?

The reverse light switch is stuck or defective.


Electrical problem on 1997 dodge SST Dash lights and rear tail lights not working All fuses good Anyone out there have any suggestions?

try a test light on both sides of the fuse, tail and dash lights are on the same circuit


2002 Chevy Trailblazer wants to cut off when stop at red lights or stop signs or it will jerk forward does anyone know what is causing this problem?

how


Could anyone tell my why my 1993 Pontiac Trans Ports rear lights are always on and only the left signal lights wont work does anybody know the electricle problem and how to solve it?

A broken wire or short in the wiring.


Is Dakota fanning like guys?

I dont know. But remember anyone bad to dakota fanning he will die


What is the problem when instead of saying yes or no someone says it 3 or 4 times?

I do not see why anyone should have a problem with that.I do not see why anyone should have a problem with that.I do not see why anyone should have a problem with that.I do not see why anyone should have a problem with that.


You think police should not speed if there not chaseing anyone or do not have there lights and sirens on?

Police should not speed if there not chasing anyone or if there lights are not on or there sirens are not on


The lights are on all the time tracker?

Your problem is most likely being caused by your daytime running lamp sensor. It's located on top of your dashboard near the windshield on the passenger side. Try disconnecting the sensor. A little more info might help narrow the problem, like , do you bright lights work when you push the turn signal lever forward, or do they only work when you pull it back, in it's temporary brights position? If this is the case, you can rest now. Don't let anyone tell you to replace the assembly on the steering column. That's a cool $200.00 bucks for a brand new part that isn't going tofixthe problem. Of course you should check all fuses that are related to high and low beams. Hope this helps you out.


Is anyone born in South Dakota?

The South Dakota Department of Health statistics for 2015 report that 12,323 babies were born in South Dakota during 2015.


Why does C220 CDi beep 3 times when you turn off the ignition?

My '96 Mercedes C220 has a constant beep in the dashboard and there is no lights that indicate a problem Anyone got an answer for this???